Wanted
Looking for 1964 coupe passenger front window and driver side fender molding 786-314-1360 james
Photos
Members
Forum
Back to Starter
Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Anders 6 minutes ago. 55 Replies 0 Likes
Ok, short refresher, last dec i relpaced starter w rebuilt from usa parts. and even then, after short runs where i got up to temp, if i shutvcar off, and then tried to start, it would drag…Continue
'63 CDV Restomod on Iron Resurrection on Velocity Channel
Started by Ian Osborne in General Discussion. Last reply by Russ Austin 5 hours ago. 1 Reply 0 Likes
I just watched an episode of a show called Iron Resurrection on Velocity Channel. They did a restomod on a pretty clean survivor '63 CDV for a customer. They did an LS3 swap, air ride, complete…Continue
1963 Ignition Bezel
Started by Lee Martin in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin 5 hours ago. 2 Replies 0 Likes
Looking for a good ignition lock nut bezel for 1963! This is the chrome piece that holds the ignition housing in place and protects painted dash from key scratches. Opening must be more than 15/16"…Continue
Floor Pans
Started by Tommy Nicolosi in Restoration Discussion 14 hours ago. 0 Replies 0 Likes
Are the floors on 1961-1964 the same???Continue
Blog Posts
HVAC Vacuum Valve Clip-need the one for the Power Control side
Posted by Norman Silverman on September 17, 2018 at 8:15pm 6 Comments 1 Like
Hi.
Update:
I removed both 7 nipple vacuum valves and called my buddy who owns a machine shop. Tomorrow we'll re-surface the valve faces and then I'll reinstall them. HOWEVER, the one that comes out easily and comes apart with no rivet is on the Power module side. It installs on one side with a small bolt, and on the other it is held on by a clip, WHICH IS MISSING ON MY CAR. I am going to assume it is the same clip that is used on the Control Module side. Anybody got one? Happy…
Continue 7 vacuum valve-need a good one or someone to recondition mine
Posted by Norman Silverman on September 15, 2018 at 5:44pm 12 Comments 0 Likes
So, I've put my 7 vacuum valve from the control head side to the test, and it failed. I looked at the instructions for re-conditioning it and unless I am missing something, the instructions are missing something (about how to take off the clip that provides the tension that holds the two pieces together).
In any case, I can't do this particular repair so I am looking for a new valve (not likely), or a good re-conditioned one, or someone who has done this before and would do mine for…
Continue
Mosiac Cadillac emblem Table
Posted by Dana G Cooper on August 30, 2018 at 10:48pm 11 Comments 2 Likes
Wanted to share a picture of a table my wife made for me to display with our 63 Coupe Deville. 
Inside door handle thread size
Posted by Michael Jarnagin on August 23, 2018 at 4:31pm 1 Comment 0 Likes
Anyone know the thread size on the inside door handle bolts mine are missing any info much appreciated
Events
© 2018 Created by Jason Edge.
Powered by
