Rebuilding a 64, 429, I’d l like a diagram(s) on the location and specs, as well as instructions (like in a shop manual) for replacing the freeze plugs. I’ve seen many kits, etc. No two the same. If…Continue
If rebuilding a 64-429 engine pls go to Help in the Header of the home page and go down to —-Rear main seal oil leak fix with bearing cap modification
The info is there for you to have a leak free rear main crank seal after…"
Rebuilding a 64, 429, I’d l like a diagram(s) on the location and specs, as well as instructions (like in a shop manual) for replacing the freeze plugs. I’ve seen many kits, etc. No two the same. If I had a diagram I could figure out what has been done to my engine.(it’s been in 2 engine shops over 13 months) I don’t want to miss any during rebuild.Please help!ByronSee More
"Welcome to the 63/64 Cadillac Website.
This site is hosted by the CLC (Cadillac LaSalle Club) 1963/64 Cadillac Chapter. Joining the website is free to everyone, however, you must be a CLC member to join the Chapter. - Click…"
Hello Cadillac family I need some help. I am having an electrical issue and trying to pinpoint what may be causing my issue. With the car running and the headlights on for a bit all of the lights…Continue
I have had another bout of what I perceive as vapor lock.. its been warm again out here in MT, and I took the car for a several hour ride. Ran flawlessly,,, until I got back to town, some slow…Continue
Is there supposed to be carpet inside the '64 Eldo center console?There is carpet in mine, and it's a deeper pile than what's on the floor (which has probably been replaced.)Here's some pix of mine.…Continue
I'm located in Melbourne, Australia and my 64 sedan de ville is stuck in the garage due to failed mechanical fuel pump. The first after market mechanical fuel pump lasted a few years before it failed & left me stranded 5 hours from home. A hire car and tow got us home. On inspection, I noticed a valve not seated within the housing. I was optimistic, pressed it into place and assumed the pump was good to go. But alas, no. From what I can now determine, the diaphragm pushrod…