Hey guys, I’m rebuilding my 429 and got to the cam and timing gear. Noticed there are holes for a dowel pin, but they’re different sizes. Everything I’ve researched so far doesn’t even talk about a…Continue
Hey guys, I’m rebuilding my 429 and got to the cam and timing gear. Noticed there are holes for a dowel pin, but they’re different sizes. Everything I’ve researched so far doesn’t even talk about a dowel pin and there wasn’t one there when I tore it down. Engine was previously rebuilt, so no telling what the builder did before me. I was thinking about drilling out the cam and press fitting a 1/4” dowel in there, but I’m hesitant to press on the camshaft.what do you guys say , dowel pin or no…See More
"Welcome to the 63/64 Cadillac Website.
This site is hosted by the CLC (Cadillac LaSalle Club) 1963/64 Cadillac Chapter. Joining the website is free to everyone, however, you must be a CLC member to join the Chapter. - Click…"
Chopperman is now a member of 63/64 Cadillac Website
After battling with my original trans for several years. Leaks, Shifter getting locked up internally, Torus Seals, More leaks, and finally a professional rebuild that lasted about 3000 trouble free…Continue
I have the 63 cdv, with the flash assister on the dash,
My hi lo beams flash back and forth intermittently. sometimes they dont start flashing at all, sometimes they will just start flasihing on and off until I hit the button on the floor to get them to stop. sometimes they sound someone is down there hitting the floor button but the lights dont respond, you can hear the click but nothing happens, as if I have no control over that floor button. I have turned off…
At long last I finally have power vent windows! I started collecting the parts 3 years ago. The one thing I could not find until recently is the 6 button driver's switch. Jason finally pulled one in and was more than generous with pricing. Thanks Jason! Installing the vent window motors was the easiest part of the project but many other tasks were spawned by this project.
There is a hole in the door panels where the window crank was. I considered putting a hub cap emblem there…
I need to pull my distributor, and still have the cork in the end of the crankshaft. What is the bolt size needed to thread a bolt in there to be able to turn the motor over with a pull handle and socket to get it to TDC exactly before I pull the distributor out?