How is the door panel taken off to access the wiring harness 

Views: 89


You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Anthony Boles on June 16, 2018 at 2:06pm
Thanks Russ
Comment by Russ Austin on June 16, 2018 at 10:46am

Depending on your model, the window switch pod of bezel, arm rests come off (see note below) The door unlock handle comes off, 3 screws on the bottom edge of the door card, the vent window crank, mirror stem knob comes off.  The lock knob unscrews.  Use a putty knife to pry the sides of the door card away. There are nail type pins holding the side in place.  The door card will lift up, and away from the top lip. Then bring the door card down and off the mirror post.

Note; depending on the model, series 62 or 60 63, the arm rest is different. Series 62 has a simple arm rest with 3 screws, and a switch pod with 2 screws for the plastic cover and 2 screws for the pod.

Others have a long arm rest and switch bezel built into one.  The switch faceplate will have a screw in the front and a screw in the back, under the door unlock lever. The back screw also holds in a chrome trim plate above the door unlock lever.

With the switch faceplate removed, remove the door unlock lever. Look for a screw that holds the plastic tab on the arm rest. It is by the door unlock lever.


  • Add Photos
  • View All


clock problem

Started by paul k in General Discussion. Last reply by Kevin Campbell 20 minutes ago. 3 Replies

I would like to ask how to disconnect front clock knob ?Thank youPaulContinue

1963 caddy 2 door hardtop for sale

Started by paul in For Sale 59 minutes ago. 0 Replies

Just car body and frame. No engine or trans, have front and back seats

Dark cadillac blue engine code anybody

Started by Haris dizdarevic in General Discussion. Last reply by Christopher Codd 3 hours ago. 5 Replies

After a long thought of what color I should paint my cadillac I've finally decided I'd like to paint it the same color as the bill hirsch cadillac dark blue like the engine paint I'm wondering what…Continue

Exhaust Manifold

Started by Travis Phillips in Wanted to Buy. Last reply by Travis Phillips 5 hours ago. 6 Replies

I am in need of a Left Hand Exhaust Manifold for my 1963 Park Avenue 390.Continue

Blog Posts

64 Recirc/Fresh Air Door Actuator replaced; FROM THE INSIDE.

Posted by Norman Silverman on February 4, 2019 at 11:21pm 8 Comments

I am happy to report that I have successfully replaced the Fresh Air/Recirc door actuator that is located on the blower box-and have done so without having to remove the blower box. I did it by taking out the glove box and attacking it from the back.  It took several days, LOTS of patience and some band-aids, but it is done. THE most difficult part -BY FAR- is to remove and then replace the screw that sits on the actuator arm, connecting it to the fresh…



Posted by Mike Petrey on January 13, 2019 at 12:25pm 7 Comments

Where do the flashers go in my 64 Deville Convert.  I'm thinking that's why both turn signals stopped working.

Source for Motor mounts and Trans mounts 1964 SDV

Posted by Norman Silverman on January 9, 2019 at 4:23pm 4 Comments


Where is the best place to purchase good quality motor mounts/trans mounts for my 1964 SDV? I see that Rock Auto has them for $8 and change, and others for $24 and change. Big difference. Is there a better place to buy them from?




  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service