"If it seems to be starving for fuel underload, you need to check your fuel lines from the tank to the carb. At the tank are rubber lines to the metal feed lines. They are notorious for dry rotting after 60 years, with age cracks that create a…"
-
James Fraschieri
- Male
- Minerva, OH
- United States
- Blog Posts
- Discussions (5)
- Events
- Photos
- Photo Albums
- Videos
James Fraschieri's Discussions
No power under load
Started this discussion. Last reply by a5c0048011b941599a2e58cc24e9eb2f Aug 18, 2024. 8 Replies 0 Likes
I'm doing a resto mod on a 63 deville and I want to use the stock drive train instead of an ls swap like everyone else would. The problem I'm running into right now is I have no power under load.…Continue
Transmission questions
Started this discussion. Last reply by Russ Austin May 17, 2024. 8 Replies 0 Likes
Hello all. New member and new to classic cadillacs so I have some questions. Last year I got my hands on a resto-mod 63 coupe deville project and have been making good progress till now. I don't have…Continue
James Fraschieri's Page
Latest Activity
"Check the coil, it may be going bad. Also the condenser. "
"I changed out the metering rods, re timed and re adjusted the carb and took the car down the road again. Things started out better but when I turned around about a mile down the road it was back to the same old problems. No power, wouldn't Rev…"
"The 2 adjusters are for idle only. You will need to swap out the metering rods and possibly the jets. Go to this link as it is the chart to adjust your 600 cfm carb. The stock carb is at #1 in the middle. You need to go rich so go to the…"
"Hi James,
Russ makes a great point. You might be running too lean - open the adjusters a bit. You can also check your vacuum advance with the timing light attached; reattach the vacuum and see if it advances with the car running. …"
"The carb is running lean, bump it up 2 steps for cruise and power. "
No power under load
I'm doing a resto mod on a 63 deville and I want to use the stock drive train instead of an ls swap like everyone else would. The problem I'm running into right now is I have no power under load. When cold it revs fine and sounds good but when under a load and warmed it it falls on its face and won't get out of its own way. Timing was set with a light and carb was roughed in and is close (edelbrock 600cfm) so I'm running out of ideas. Broken vacuum advance? Weak fuel pump?See More
"I have a bracket that hooks up to Edelbrock carbs for the TV rod. Comes with the attaching hardware, you just drill 1 hole in the stock bracket.
50.00 plus shipping. Please email me at russ@thecadishack.com "
"There is no vacuum to the 1963/64 Hydramatic. The Turbo Hydramatic introduced in 1964 on certain body styles had a vacuum modulator but not the HydraMatic."
"James,
There should be a vacuum modulator on the side of the transmission.
Dennis DiBari"
"My problem is I have none of the original throttle assembly so I will have to fabricate something which won't be an issue. Is there anything vacuum controlled on the transmission? "
"I am not a Hydra-Matic expert but do know you need the TV Rod. I have them like new gold cadmium plated for $65 ($48.75 for Chapter Members) with the correct connectors at both ends to connect to transmission at bottom and carb throttle plate at…"
"Most of my experience is with small block chevys so I'm a bit out of my wheelhouse on this one but I'm enjoying learning new stuff. I have never been very good with transmissions in the first place so this hydra matic is completely unknown…"
"Hi James,
Albeit I am not an expert on transmissions, that TV rod should be hooked up to the linkage, especially when higher throttle is used. Maybe Jason Edge would have the TV rod off of one of the parts cars? …"
Transmission questions
Hello all. New member and new to classic cadillacs so I have some questions. Last year I got my hands on a resto-mod 63 coupe deville project and have been making good progress till now. I don't have any of the original throttle linkage/pedal assembly including the TV rod. Would not having the TV rod hooked up yet cause the transmission not to upshift? See More
Profile Information
- Do you own any 1963 & 1964 Cadillacs? If Yes, Year & Body Style
- 1963 coupe deville
- Cadillac LaSalle Club Membership Number? (Must be a member to Join Chapter & Website)
- No
- 1963/64 Cadillac Chapter Member?
- No
Comment Wall (1 comment)
- At 4:42pm on May 14, 2024,
Jason Edge said…
Hi James, Welcome to the 63/64 Cadillac Chapter & Website. Be sure to tell us about your 63 Coupe de Ville and make yourself at home on our website. Jason.
Members
Forum
Convertible bumper jack
Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge yesterday. 8 Replies 0 Likes
My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue
Rear Main Seal Oil Leak Fix with Bearing Cap Modification
Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Tuesday. 25 Replies 4 Likes
Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue
Front grill
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion on Monday. 0 Replies 0 Likes
Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue
A Big Shout Out in Pictures to Robert Kirnard and His 49K Mile 1964 Fleetwood 60 Special!
Started by Jason Edge in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Sunday. 1 Reply 0 Likes
A Big Shout Out to Robert Kirnard, 1963-64 Cadillac Chapter Member, who just picked up this super clean and great running 49K Mile 1964 Fleetwood 60 Special. He drove it to our Carolina Region CLC…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
Videos
© 2025 Created by Jason Edge.
Powered by
