Paul George
  • Male
  • Indianapolis, IN
  • United States
Share on Facebook
Share on Facebook MySpace

Paul George's Friends

  • Marty Smith
  • Jason Edge

Paul George's Discussions

LH Exhaust Manifold

Started this discussion. Last reply by Paul George Feb 7, 2017. 2 Replies

Looking for a exhaust manifold for a 63 Fleetwood. If anyone has one used or know of a good source for new please let me know.

LH Exhaust Manifold

Started Feb 5, 2017 0 Replies

Looking for a exhaust manifold for a 63 Fleetwood. If anyone has one used or know of a good source for new please let me know.

 

Paul George's Page

Profile Information

Do you own any 1963 & 1964 Cadillacs? If Yes, Year & Body Style
1963 Fleetwood 60 Special
Cadillac LaSalle Club Membership Number? (Must be a member to Join Chapter & Website)
yes 28425
1963/64 Cadillac Chapter Member?
yes

Paul George's Photos

  • Add Photos
  • View All

Paul George's Blog

Front Upper Control Arm

Posted on October 6, 2013 at 10:08am 1 Comment

My bushings are worn out of my 63 Fleetwood and was wondering if its just better to go ahead and replace the whole arm or just the bushings? Also was wondering about the size.....seen a 1 1/2  and a 1 7/16 would it matter on the size if I buy the complete arm with the bushings already installed?

Comment Wall (2 comments)

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

At 8:30pm on November 18, 2012, Jason Edge said…

Hi Paul, It was good to have you visit yesterday and glad to see someone put the dual exhaust to good use. Post some pictures of your Caddy when you get it ready! Jason.

At 10:33am on November 13, 2012, Jason Edge said…

Welcome to the 63/64 Cadillac Website.

Be sure and check out all the links and pages and make yourself at home.

Jason

 
 
 

Photos

  • Add Photos
  • View All

Forum

Rear Upper trailing arm, Rear ball joint, Rear lower trailing arms

Started by Norman Silverman in 1963/64 Cadillac Specific Discussion. Last reply by Norman Silverman 2 hours ago. 4 Replies

Has anyone replaced any/all of these parts? If so, where did you buy them? Also, and most importantly, did replacing them change any characteristic of the car, like maybe reduce driveline…Continue

Dino's Gas Lines Removed - Clean Up or Replace --> Member Advice

Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge 6 hours ago. 11 Replies

As part of my undercarriage cleanup and and restoration of my 64 Coupe de Ville 'Dino', I removed both gas lines (my car has AC so it has a 5/16" supply line and 1/4" vent return line) to gain better…Continue

1963/64 Cadillac Starting - Cranking System Basics

Started by Jason Edge in 1963/64 Cadillac Specific Discussion. Last reply by Chris McBride 7 hours ago. 17 Replies

I have had this info written up for some time and meant to post so here it is. I will link to this from our Help Page:1963/64 Cadillac Starting - Cranking System Basics Wiring You have a positive…Continue

Free cylinder heads and diffential in Phoenix metropolitan area

Started by Chris McBride in 1963/64 Cadillac Specific Discussion 7 hours ago. 0 Replies

Cleaning the shed - free partsI have no interest in shipping.Parts are located in Phoenix metropolitan area. Zip code is 85257. Nearest major intersections are Thomas Road and Scottsdale Road.Two…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service