I noticed a broken ground strap on my 1963 Convertible last week and I can't figure out where the other end should go. As you can see in the picture below, it is connected on one end to the top of a steer/suspension piece on the left side of the car near the dipstick. Where should the other end be attached? I had the power steering ans steering rack redone last fall, so perhaps with this rework it is no longer needed.

I've got the wipers that don't like to stop issue - I know it is due to a sticking wiper relay control switch, but perhaps it is sticking because it needs a better ground and this is a contributor to the issue. It amazes me how even tough the whole car is one big ground, how often electrical issues are ground related!

Views: 366

Reply to This

Replies to This Discussion

Karl , I believe it attaches with a ring type crimp fitting  under the bolt head  at the bushing.  Other side should be the same. HTH

Robert is correct. The ground strap goes from control arm to control arm shaft and attaches via a ring connector on the rear facing control arm bolt on both sides. See picture below. If you need the ground straps I have them for $5 each. 

Great info - Thanks.

On the wiper, it is definitely the relay that sticks, Not sure if I can find a replacement to replace just that part. I put some silicon lube on it that helped, but the problem is back again...

As Mark noted this ground strap is part of the static collection circuit and in the end of your spinning "hub caps" are the static collectors. It is my understanding that with today's resistor spark plugs and shielded cables you usually don't have any issue with static interference anyway, especially with fm. If you have am, or just picking up high pitched wining noise this could help to reduce and eliminate that noise. For most the broken control arm to shaft ground wire would just be an unsightly annoyance and something you just want to correct or remove for appearance. If you do have noise in the radio, check to see if you have the static collectors. I also have them. If nothing else they make great nipple shields... Hey Tony!?

 

Aw, Jason you beat me to it. I was just searching for the discussion where you referred to these as "nipple shields" LOL! That one never gets old!

Well we know with the mention of Nipple Shields, Tony is sure to chime in later. Gotta have some fun with this techy stuff!

Tony, I knew the nipple shields would get you wound up. LOL

RSS

Photos

  • Add Photos
  • View All

Forum

Trivia #29 - What Movie Is this?

Started by Jason Edge in Trivia. Last reply by Jason Edge yesterday. 12 Replies

It has been a while since we did some trivia and I was watching a movie last night and saw this 1964 Coupe de Ville that briefly makes an appearance.   The Trivia Question is: What Movie Is this?…Continue

A 2nd Look At 1964 Cadillac Print Ad with an Alternate Version

Started by Jason Edge in General Discussion on Saturday. 0 Replies

In our recent look back at standard 1964 Cadillac color print ads, one was "FIRST ONE UP GETS THE CADILLAC". Eric DeVirgilis pointed out there was an alternate version where the lady gets the…Continue

My '64 Deville Radio Rebuilt and Upgraded.

Started by Michael Vogler in 1963/64 Cadillac Specific Discussion. Last reply by Kurt on Friday. 4 Replies

My original '64 Devile radio has been rebuild and upgraded.  Can't wait to get in back in the car!https://youtu.be/DgYqoV290KwContinue

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Friday. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Blog Posts

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

accumulator dryer

Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments

Who rebuilds original AC  accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year ,  There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A    What  is everyone using ? I would prefer to be as original as possible. Thanks

'63 Eldorado trumpet horn + 2 standard horns restoration

Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment

My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns. 

There is a restoration service called The Horn Works who my son…

Continue

Videos

  • Add Videos
  • View All

© 2024   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service