1963/64 Cadillac Specific Discussion (1,778)

Discussions Replies Latest Activity


Gents, i know about the elusiveness of the right hand mirror. During the restoration of my coupe Deville i have discovered that the right h…

Started by Cliff Johnston

8 Jan 10, 2015
Reply by Dave Schneider

Trim Retention

I have been working on removing all of the trim from my car in preparation for paint and body work. It has been a major pain because in the…

Started by Daniel Noda

1 Jan 9, 2015
Reply by Russ Austin

Reverse lights

So I decided to fix a few small issues on the 64. I pulled the non working clock out,fixed it,cleaned it up and put it back in. She works p…

Started by greg

8 Jan 6, 2015
Reply by Jason Edge

2015 grand national

Anyone coming to the 2015 grand national in My back yard in Brookfield wi this year?

Started by Phil Jakubowski

0 Jan 1, 2015

429 valves, lifters, etc.

After an engine rebuild by a local shop, I noted considerable upper engine noise (i.e.; rockers, lifters etc.), particularly when the engin…

Started by John C.Churchill

9 Dec 31, 2014
Reply by Jason Edge

64 firing order?

Can someone please post what the proper firing order is? I just replaced the coil, plugs, and plug wires? I replaced the new plug wires the…

Started by Brad Foran

18 Dec 31, 2014
Reply by Jason Edge

Armrest Pad Retaining Clips

Hello all, anyone have an idea where I can get some of the clips that hold the upholstered door armrest pads to the plastic lower armrest?…

Started by Eric K

3 Dec 29, 2014
Reply by Jason Edge

cooling problem solved

I have a 64 Fleetwood and in the summertime with the a/c cranking when I would be in traffic or going slow it would always run warm....clos…

Started by greg

5 Dec 28, 2014
Reply by Todd Lentz

bagged 64 shock mounts

No Description

Started by steve white

2 Dec 21, 2014
Reply by Phil Jakubowski

Shooting black from tailpipe

Hey guys I have the eldelbrock 750 electric choke carb on my 64 429. On cold start it shoots lots of black soot out the tailpipe painting m…

Started by Chase C.

7 Dec 21, 2014
Reply by Tony and Ginny 429



  • Add Photos
  • View All


Battery, alternator not charging

Started by Keith Benning in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 55 minutes ago. 11 Replies

Hello All, after replacing the voltage regulator, alternator, checking and replacing wires to alternator plug, test voltage on battery, good, voltage on alternator good.  Checked ground with multi…Continue

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge 5 hours ago. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

'64 Cadillac speedometer cable - transmission to cruise control box

Started by Don Moyer in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 20 hours ago. 3 Replies

Hi folks - I'm new to this forum, but have owned my '64 convertible since 1993.  I recently replaced the speedo gear and seal in the transmission due to fluid leak, and noticed that the end of the…Continue

1963 transmission dipstick tube came out

Started by Karl Schwarz in 1963/64 Cadillac Specific Discussion. Last reply by Kurt yesterday. 1 Reply

I went to check the fluid in the transmission on my 1963 Series 62 convertible and when I pulled on the dipstick ring the whole tube came out. I got it back in the hole, sort of, but it is loose.…Continue

Blog Posts

Frame Markings

Posted by Gene McIlroy on August 12, 2019 at 6:26pm 1 Comment

Just got my frame back from powder coating so thought I would post photos of the front and rear frame markings.…


Lining up the drive shaft

Posted by Dominic Salemi on August 12, 2019 at 5:47pm 2 Comments

Can anyone shed some light on how to position the complete drive shaft in the correct position? I want to make sure my drive shaft is installed properly.



Upper A Arm Rubber Bumpers

Posted by Gene McIlroy on August 12, 2019 at 1:30pm 3 Comments

I have found a very good replacement part for the Upper A Arm Bumpers.  The top part is identical to the originals the bottom can be used as is or after a few minutes with a belt sander can be ground to the V shape as the originals were.  The replacement bumpers are for a 2001 to 2005 S10 Sanoma or Blazer.  Part number is on the box in the photos.  First photo is the box next to the box is the S10 part and an original.  Next photo shows my sanded down part next to an original.…


Roof motor

Posted by Dermot Robinson on August 11, 2019 at 8:44am 2 Comments

Replacing my convertible roof motor.

Has anyone any experience or advice on replacing the roof motor on a 1964 Cadillac Deville .




  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service