Michael Vogler
  • Male
  • Huntington Beach, CA
  • United States
Share on Facebook
Share
  • Blog Posts
  • Discussions (29)
  • Events
  • Photos
  • Photo Albums
  • Videos

Michael Vogler's Friends

  • Russ Austin
  • Jason Edge

Michael Vogler's Discussions

Dash Trunk lid warning light and am/fm radio tell-tale lights

Started this discussion. Last reply by Jason Edge Apr 29. 4 Replies

I installed the mercury switch trunk light and it works perfectly!  I half-expected the dash trunk warning light to work as well, but of course it doesn’t.   I crawled under the dash and there is no…Continue

Stuck power antenna

Started this discussion. Last reply by Russ Austin Apr 16. 4 Replies

The mast on my power antenna is stuck up.  I can hear the motor engage when I pull/push the knob, but no movement.  The mast seems be rigid on the push wire or rod which wont move.  Any thoughts…Continue

‘64 DeVille mercury trunk light

Started Mar 28 0 Replies

Does anyone have a mercury switch trunk light for a ‘64 deVille, or know where I can get one?Continue

Back of bench seat rear courtesy light switch

Started this discussion. Last reply by Michael Vogler Mar 28. 13 Replies

My bench seat switch circuit is dead.  I found the hot wire cut under the seat, but cannot locate the other end of the hot wire.  The wiring diagram indicates the it is connected to the rear cigar…Continue

 

Michael Vogler's Page

Latest Activity

Jason Edge replied to Michael Vogler's discussion Dash Trunk lid warning light and am/fm radio tell-tale lights
"From the factory the feed wire runs from the trunk release actuator assembly mounted on the back wall down the left side of the car under the door sill(s) and behind the dash. It's a pretty simple setup... green wire on ground wire from the…"
Apr 29
Karl Schwarz replied to Michael Vogler's discussion Dash Trunk lid warning light and am/fm radio tell-tale lights
"How hard is it to install the tell-tale bulb for the trunk? I looked through the service manual and could not find any info on how it would normally be wired. If I decided I wanted to install the tell-tale bulb, could I use the exiting mercury…"
Apr 29
Michael Vogler replied to Michael Vogler's discussion Dash Trunk lid warning light and am/fm radio tell-tale lights
"Thank, Jason. That’s what I thought (and gleaned from the service manual)."
Apr 25
Jason Edge replied to Michael Vogler's discussion Dash Trunk lid warning light and am/fm radio tell-tale lights
"The small AM & FM indicator lights are internal to the radio. There is a separate display light that plugs into the top of the radio that comes on with the rest of the dash lights. The instrument panel trunk warning light is only used with cars…"
Apr 25
Michael Vogler posted a discussion

Dash Trunk lid warning light and am/fm radio tell-tale lights

I installed the mercury switch trunk light and it works perfectly!  I half-expected the dash trunk warning light to work as well, but of course it doesn’t.   I crawled under the dash and there is no bulb or bulb socket present.  Did all models come with the trunk warning light, or was it an option?Also, I noticed recently that the am/fm tale-tale light have gone out.  Are those interior to the radio unit, or bulbs I can replace without having to remove the radio?I would like to thank everyone…See More
Apr 25
Russ Austin replied to Michael Vogler's discussion Stuck power antenna
"You can get a new antenna mast from CaddyDaddy.com    I use them all the time. "
Apr 16
Tony and Ginny 429 replied to Michael Vogler's discussion Stuck power antenna
"Often the nylon mast will break and can be replaced  The motor makes a clicking sound but nothing moves in any direction if broken  If the nylon mast is not broken I would think the motor that pulls the mast down ( and up )  WB the…"
Apr 16
Michael Vogler replied to Michael Vogler's discussion Stuck power antenna
"Thanks, Kurt. I have a shop manual and will get to reading!"
Apr 16
Kurt replied to Michael Vogler's discussion Stuck power antenna
"I can't stand a conceited (stuck up) antenna. Sorry, couldn't resist : ). Anyway, do you hear a clicking sound when the antenna motor is running? There is a nylon cord that pushes/pulls the mast up & down. If the mast is simply stuck…"
Apr 16
Michael Vogler posted a discussion

Stuck power antenna

The mast on my power antenna is stuck up.  I can hear the motor engage when I pull/push the knob, but no movement.  The mast seems be rigid on the push wire or rod which wont move.  Any thoughts about getting it unstuck?MikeSee More
Apr 16
Michael Vogler posted a discussion

‘64 DeVille mercury trunk light

Does anyone have a mercury switch trunk light for a ‘64 deVille, or know where I can get one?See More
Mar 28
Michael Vogler replied to Michael Vogler's discussion Back of bench seat rear courtesy light switch
"Gentlemen. You guys are amazing. Reviewing/tracing the door jam circuits, I realized I inadvertently jumped the 2 prong door jam switched incorrectly. I re-jumped the two “hots” together and Interior lights work perfectly! Thank you very…"
Mar 28
Kurt replied to Michael Vogler's discussion Back of bench seat rear courtesy light switch
"Without the 3 prong switch, 2 circuits are tied together meaning grounding one will ground the other. I guess you can chose whether to tie the map light to the front courtesy lights or leave it as is. A 3 prong switch is what you need to separate…"
Mar 28
Michael Vogler replied to Michael Vogler's discussion Back of bench seat rear courtesy light switch
"Russ, do you think I jumped the wrong prong on the two prong switch, effectively making it a one prong)? I could move the jump to the other prong?)"
Mar 28
Kurt replied to Michael Vogler's discussion Back of bench seat rear courtesy light switch
"I had an issue once where turning on the map light would also turn on the courtesy lights. It was the the pin switch allowing grounding of the courtesy lights. If not the pin switches, trace out what is allowing ground to all lights."
Mar 28
Michael Vogler replied to Michael Vogler's discussion Back of bench seat rear courtesy light switch
"You know what? As I think about it, I recall when I replaced the door switches about six months ago, i bought 2 prong switches (couldn't find 3 prong) and jumped the hot for the four lights to work. I think you might be right: it’s likely…"
Mar 28

Profile Information

Do you own any 1963 & 1964 Cadillacs? If Yes, Year & Body Style
Long ago.Looking for another ‘64 deVille Convertible
Cadillac LaSalle Club Member? If Yes, Membership #?
Yes
1963/64 Cadillac Chapter Member?
No

Comment Wall (1 comment)

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

At 9:21am on October 11, 2020, Jason Edge said…

Welcome to the 63/64 Cadillac Website.

This site is hosted by the CLC (Cadillac LaSalle Club) 1963/64 Cadillac Chapter. Joining the website is free to everyone, however, you must be a CLC member to join the Chapter. 

- Click on www.join.6364cadillac.com for more information on joining the 1963/64 Cadillac Chapter and the Cadillac LaSalle Club.

Be sure and check out all the links and pages and make yourself at home. The Help Page at www.help.6364cadillac.com will have links to many useful articles and information about our Cadillacs.

 
 
 

Photos

  • Add Photos
  • View All

Forum

Chapter Member? Got a 63 or 64 Cadillac for Sale? Let's Run it in the Newsletter!

Started by Jason Edge in For Sale. Last reply by Jason Edge 3 hours ago. 4 Replies

One of the new features of recent newsletters is a Member Classified Cars for Sale section.…Continue

vacuum canister

Started by Walt Timmerman in General Discussion. Last reply by Rob Shatsnider 8 hours ago. 15 Replies

what is the vacuum canister for that is behind the drivers front fender?After removing my fender I see its got a hole in the top but nothing is hooked to it and no line is laying there.Any help would…Continue

New Batch of Embroidered Iron-On 1963/64 Cadillac Chapter Patches - $4 each

Started by Jason Edge in Chapter Discussion. Last reply by mark zimmerman 13 hours ago. 10 Replies

As noted in our August 1963/64 Cadillac Chapter Newsletter:Around 6 years…Continue

Tags: Available, Patches, Chapter, Cadillac, 1963/64

63 coupedebille fuel pump issues

Started by Daniel Grande in 1963/64 Cadillac Specific Discussion. Last reply by Daniel Grande 22 hours ago. 9 Replies

I have a 63 cadillac and I took it to a mechanic for a motor tune up long story short the fuel pump gave out and hes tried twice to order it and he says it didnt fit the original pump is smaller on…Continue

Blog Posts

New vehicle in the club

Posted by Patrick Westphal on June 17, 2021 at 4:00pm 1 Comment

I was successful in getting a vehicle from the New York contact I talked about at the last club meeting. I am still trying to figure out how to post a picture of the vehicle that is tied with this comment so if you see a random picture of a black convertible in a yard, that's me haha.  …

Continue

Torque converter grab when idling in Drive

Posted by Cliff Johnston on June 14, 2021 at 8:47pm 2 Comments

Hi Everyone, been quite a while since i have been on here.

I have had an issue with the idle on my 64 Coupe Deville ever since i have had it.

With the Idle set high enough that it is smooth, but still a nice idle, the RPM seems only slightly too high for the stall of the Torque Converter. And therefore it tends to sit there and grab and lunge a bit. So until now, i have been putting the car in Neutral at the lights to stop this happening.

I've had the car dyno tuned and…

Continue

Can you help? Driveshaft Question....

Posted by Chris on May 30, 2021 at 8:55am 1 Comment

Hello!

Newbie to the group here - we have already found tons of invaluable information on the board, so thanks! We are restoring a 1963 Series 62 Convertible. We are wondering if anyone knows of a source to buy the propellor yoke flange (that bolts to the pinion flange) for the driveshaft? One of our ears partially broke off. Not sure if we can buy just the yoke flange as an aftermarket part, or if it has to be rebuilt by a welder/fab guy? Maybe a salvage yard for a source? Again, any…

Continue

Thank you Kurt re: VIN location

Posted by Robert Pellow on April 19, 2021 at 1:07pm 0 Comments

I just wanted to say a thank you to Kurt for steering me to the tech tips page on V.I.N. locations.  Excellent information.  Thanks a bundle.

Robert Pellow

Videos

  • Add Videos
  • View All

© 2021   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service