"Where is the car located? getting rid of it?"
Russ Austin's Discussions
For sale; Hydra Matic transmission
Started Aug 15 0 Replies 0 Likes
Known good Hydra Matic transmission for a 63 64 Cadi.Came out of my driving 63 coupe. I went the LS route.Resealed the pan, speedo drive, front and rear seals.Comes with a new rear…Continue
64 crank adaptor
Started Feb 2 0 Replies 0 Likes
New crank adaptor ring. Now available at […Continue
new 64 THM filters for sale..
Started Dec 27, 2024 0 Replies 0 Likes
I have 2 new filter kits for the 64 THM transmission. 20.00 each.Please email me at russ@thecadishack.com …Continue
63 Coupe deVille for sale
Started Dec 23, 2024 0 Replies 0 Likes
I have a 63 CDV with factory bucket seats for sale. Engine runs and I have not driven the car. 44,000m miles, clean AZ title. I believe this is a California car as there is an emissions sticker on…Continue
Russ Austin's Page
Latest Activity
"You will need to remove the blower case, or at least move it upwards. "
"The turn signal arm screw out. There are 2 flat spots where a wrench will fit. The shift lever pin is pushed out. I use a small brass punch and a hammer. Yes, there is a shim plate, so get that as well when the arm comes out. Take not as…"
"Put it back the way you found it will work. It sounds like the prev owner clocked the distrib wrong and wired it accordingly. If it works, it works. "
"I have one on a [arts car I can pull off and test. Please send me an email to; russ@thecadishack.com "
"One of those big hoses go to the NSS and to the parking brake vacuum canister."
"Jose, I replied to your email. "
"I have both of the cover panels, please email me at russ@thecadishack.com "
"I use a flat gasket that is found at hardware stores. One side has a sticky side so it sticks. They are available in many sizes. "
vacuum lines B4
"Rick, these engines are high compression, unless it was shipped overseas as a low compression engine. The engine VIN stamp will have a special character in it.
I have good intake manifolds for alot less than 400 bucks,…"
"I have the arm rests, please send me an email to russ@thecadishack.com "
vacuum lines B4
"The choke tube is not associated with intake vacuum. If it is, there is a crack in the intake allowing that to happen. The choke tube runs through the exh passage so the fresh air being drawn in is heated for the choke assembly. "
"My sedan has an aftermarket booster and master cylinder. The brake pedal is rock hard as in there is no swish in the pedal before there is braking, or another way to say it is there is no pedal drop before I have brakes being applied. "
"If the booster is an aftermarket one, they are rock hard on the pedal. I have one in my sedan and the brakes are great. A vac pump is not necessary unless the vacuum is low. if the vac is low, then there are engine problems, not brake…"
For sale; Hydra Matic transmission
Known good Hydra Matic transmission for a 63 64 Cadi.Came out of my driving 63 coupe. I went the LS route.Resealed the pan, speedo drive, front and rear seals.Comes with a new rear mount.625.00 located in Vail AZ. U pick up or I can put it on a pallet to ship. I use engineshipping.com all the time. Please email me at russ@thecadishack.com…See More
Profile Information
- Do you own any 1963 & 1964 Cadillacs? If Yes, Year & Body Style
- 63 series 62 4 window sedan. 63 CDV
- Cadillac LaSalle Club Membership Number? (Must be a member to Join Chapter & Website)
- order #
- 1963/64 Cadillac Chapter Member?
- no
Comment Wall (1 comment)
- At 10:48am on December 12, 2023,
Jason Edge said…
Hi Russ, Welcome Back to the Cadillac & LaSalle Club, The 1963/64 Cadillac Chapter and our Chapter Website.
It is good to have you back with us!
Photos
Members
Forum
Rear Upper trailing arm, Rear ball joint, Rear lower trailing arms
Started by Norman Silverman in 1963/64 Cadillac Specific Discussion. Last reply by Dave Fehrle 7 hours ago. 1 Reply 0 Likes
Has anyone replaced any/all of these parts? If so, where did you buy them? Also, and most importantly, did replacing them change any characteristic of the car, like maybe reduce driveline…Continue
Wheels for 1964 Cadillac Deville vs 1962 Cadillac Wheels
Started by Cesar Espinosa in 1963/64 Cadillac Specific Discussion. Last reply by Cesar Espinosa 10 hours ago. 6 Replies 0 Likes
Good afternoon,I need to purchase two wheels for my 1964 Cadillac Deville and all advertisements I've seen on eBay mention that the 1961-63 wheels fit that 1964 Cadillac. Is this true? Were all…Continue
64 window power for the electrically inclined
Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion 15 hours ago. 0 Replies 0 Likes
HI,, I recently got a 64 convert. all was well roughly, until I trailered it home. fixed the transmission issue..Now, passenger door window wont operate. did fine up till about a week ago. It has…Continue
Dino's Gas Lines Removed - Clean Up or Replace --> Member Advice
Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge on Thursday. 9 Replies 0 Likes
As part of my undercarriage cleanup and and restoration of my 64 Coupe de Ville 'Dino', I removed both gas lines (my car has AC so it has a 5/16" supply line and 1/4" vent return line) to gain better…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
-
November 23, 2025 - 63/64 Cadillac Chapter Zoom Meet-Up
November 23, 2025 from 7pm to 8:30pm – Zoom
0 Comments 0 Likes
© 2025 Created by Jason Edge.
Powered by
