"Nice meeting you too at the chapter meeting. I hope to see you next year in Murfreesboro. "
-
Robert Schles
- Male
- Wilmington, DE
- United States
- Blog Posts (6)
- Discussions (42)
- Events
- Photos (1)
- Photo Albums
- Videos
Robert Schles's Discussions
Parking Bulb Removal
Started this discussion. Last reply by Robert Schles Jun 6, 2024. 7 Replies 0 Likes
Can someone advise the best way to replace the parking light bulb? ThanksContinue
120 Years of Cadillac
Started this discussion. Last reply by Jason Edge Dec 18, 2023. 2 Replies 0 Likes
Has anyone else noticed the 120 Years of Cadillac advertisement? It mentions the 1964 model twice: "The 1964 Cadillac Series 62 Coupe combined style with power, boasting an all-new V8 engine with…Continue
Engine Removal With Hood On
Started this discussion. Last reply by a5c0048011b941599a2e58cc24e9eb2f Jul 12, 2023. 11 Replies 0 Likes
I'm pulling out the engine on my 64 and was wondering if it can be taken without removing the hood. I just had the engine rebuilt. After putting it in and firing it up, I discovered a bad wrist pin…Continue
Upper Control Arm Installation
Started this discussion. Last reply by Robert Schles Apr 10, 2023. 3 Replies 0 Likes
I removed my upper control arms and replaced the bushings. I supported the lower control arms with jack stands. I reinstalled the upper control arms on the sub frame but now have about 2.5 inches…Continue
Robert Schles's Page
Latest Activity
"The hard luck award is hanging in a place of honor in my garage. "
"Jason, It was a fun Grand National with lots of great cars. Thanks for posting pictures of my Eldorado! "
"This may have to wait until after the GN. Thanks"
"I had that with the last parts car. Take flat pry bar and and wrap flat end in cloth and wedge above the top of park light grill and beneath the headlight eyebrow trim and assembly that protrudes forward and gently lift up enough to get the…"
"Yes I tried that but there is not enough clearance to pull out the grill. I think I have an issue with bumper alignment. "
"A trick for getting the bulb out since they can sometimes be hard to push in and turn at the same time, is to use a large rubber hose, like a 3/4" or size that is just smaller than diameter of bulb with a good length, a foot or so, so you can…"
"Remove the 4 screws, 2 up top & 2 at bottom and pull the chrome park light grill off.The lens sometimes stick to the gasket. Liberally spray the perimeter with WD40 and take a small flat screwdriver and gently pry the lens off the…"
"The front parking/turn signal bulb. I can't remove the chrome grill in front of the lens to access the bulb. "
Parking Bulb Removal
Can someone advise the best way to replace the parking light bulb? ThanksSee More
"Delaware doesn’t allow custom plates to start with a number. Fortunately no one else in the state has a 64 Cadillac plate. "
"The car is a great restoration project with a very solid body and good engine. Good luck with the sale Earl."
"That is fantastic and great timing as I have started a side project of cataloguing and posting the 1963 and 1964 Cadillac related adds. Here is a screen shot of both. "
120 Years of Cadillac
Has anyone else noticed the 120 Years of Cadillac advertisement? It mentions the 1964 model twice: "The 1964 Cadillac Series 62 Coupe combined style with power, boasting an all-new V8 engine with more horsepower and torque. Today, the powerful Escalade-V is the first SUV to offer the V-Series badge.""Cadillac offered the first automatic climate control system in 1964. Cadillac’s dedication to comfort continues with LYRIQ’s next-generation Active Noise Cancellation and seating architecture that…See More
Profile Information
- Do you own any 1963 & 1964 Cadillacs? If Yes, Year & Body Style
- Found a '64 Eldorado.
- Cadillac LaSalle Club Membership Number? (Must be a member to Join Chapter & Website)
- 6715
- 1963/64 Cadillac Chapter Member?
- Yes
Robert Schles's Photos
Robert Schles's Blog
Does anyone know where I can get the bushings for AC compressor mount on the 429?
Posted on February 21, 2023 at 11:45am 2 Comments 0 Likes
I've looked at the usual rubber sources but couldn't find any.
64 Hood Hinge Color?
Posted on June 27, 2019 at 4:46pm 2 Comments 0 Likes
Can someone tell me what color the hood hinges should be? I've seen both silver and gold cadmium plating colors on the cars. Thanks
OPG now shipping right hand mirrors
Posted on February 23, 2017 at 9:56am 11 Comments 0 Likes
On 12/14/15 I placed an order with Original Parts Group for a right hand mirror for my 64. They told me they were back ordered. Every few months I would email them asking about the mirror and got the same response. After a year I gave up. Yesterday I got an email saying they shipped the mirror. It will be a little project to install but nice very nice have.
Comment Wall (1 comment)
- At 9:10pm on August 1, 2014,
Jason Edge said…
Welcome to the 63/64 Cadillac Website.
Be sure and check out all the links and pages and make yourself at home.
Also check out and join the national Cadillac LaSalle Club and our Chapter. To Join the CLC click on https://www.cadillaclasalleclub.org/joinrenew
Jason Edge
Director 1963/1964 Cadillac Chapter
Photos
Members
Forum
Burning Rubber
Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Linda M. Brooks yesterday. 5 Replies 1 Like
Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light? Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue
Gas gauge only reads half when full
Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Wednesday. 1 Reply 0 Likes
Hi everyone, I installed a new gas tank sender in my 63 after bench testing it and confirming ohm range on the bench.However after installing and filling it up, it only reads half full after filling…Continue
64 Brakes
Started by Jeff Donaldson in General Discussion. Last reply by Dennis P. DiBari on Monday. 1 Reply 0 Likes
Hi,It's time to do a brake job on my Fleetwood. When I imported my car from the US to Canada I had to have my car safety inspected before I could license it in the Privince of BC. After the…Continue
Heater Core Replacement
Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson on Sunday. 6 Replies 0 Likes
I'm currently rounding up parts for a heater core replacement in my 1964 Deville. I'm looking for replacement hoses that connect to the heater core itself. It's a factory a/c car and has the metal…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
New old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2026 Created by Jason Edge.
Powered by
