got house built i have been slaving over for last 5 months,, now have time to work on the 63.

I just ordered some rubber parts for window rail, rear window pillar, and the window and out,

are there any other additional pieces i need to order, like clips or the like.  and is there any particular method to use or will the manual explain the removal process.


Views: 59

Reply to This

Replies to This Discussion

If you are removing the door glass, just take the 2 screws out that hold the roller bar to the window frame. The glass and frame will lift right up once you take the 2 screws out and remove the roller bar from the frame.

I was alos referring to the rubber strip that attached to the top,were the top o the window seals against the body, and the front of the door frame fits agains the front window pillar.. 

are those pulled out and then reapplied with an adhesive or are there screws on pins or clips on the underside that have to be removed and replaced...

The top roof line seal is held in place by the lips of the trim. I have used adhesive before. First time you install it, don't use adhesive, so you cab check the fit.

ok,  thanks

i ordered the felts, etc from rtrw,  and i just got through reading a long string on the suspension and rtrw and steeled etc,, was all that about the parts being inferior or one being the middle man for the other for suspension parts or does it apply to all there parts,,,,,, just curious as when i orders, i never got a response from rtrw, so i checked on the order and they said all th parts had to be ordered,,  


just a possible issue with rear control arm bushings not other products they sell 




  • Add Photos
  • View All


Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge 4 hours ago. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Battery, alternator not charging

Started by Keith Benning in 1963/64 Cadillac Specific Discussion. Last reply by Keith Benning 13 hours ago. 10 Replies

Hello All, after replacing the voltage regulator, alternator, checking and replacing wires to alternator plug, test voltage on battery, good, voltage on alternator good.  Checked ground with multi…Continue

'64 Cadillac speedometer cable - transmission to cruise control box

Started by Don Moyer in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 18 hours ago. 3 Replies

Hi folks - I'm new to this forum, but have owned my '64 convertible since 1993.  I recently replaced the speedo gear and seal in the transmission due to fluid leak, and noticed that the end of the…Continue

1963 transmission dipstick tube came out

Started by Karl Schwarz in 1963/64 Cadillac Specific Discussion. Last reply by Kurt yesterday. 1 Reply

I went to check the fluid in the transmission on my 1963 Series 62 convertible and when I pulled on the dipstick ring the whole tube came out. I got it back in the hole, sort of, but it is loose.…Continue

Blog Posts

Frame Markings

Posted by Gene McIlroy on August 12, 2019 at 6:26pm 1 Comment

Just got my frame back from powder coating so thought I would post photos of the front and rear frame markings.…


Lining up the drive shaft

Posted by Dominic Salemi on August 12, 2019 at 5:47pm 2 Comments

Can anyone shed some light on how to position the complete drive shaft in the correct position? I want to make sure my drive shaft is installed properly.



Upper A Arm Rubber Bumpers

Posted by Gene McIlroy on August 12, 2019 at 1:30pm 3 Comments

I have found a very good replacement part for the Upper A Arm Bumpers.  The top part is identical to the originals the bottom can be used as is or after a few minutes with a belt sander can be ground to the V shape as the originals were.  The replacement bumpers are for a 2001 to 2005 S10 Sanoma or Blazer.  Part number is on the box in the photos.  First photo is the box next to the box is the S10 part and an original.  Next photo shows my sanded down part next to an original.…


Roof motor

Posted by Dermot Robinson on August 11, 2019 at 8:44am 2 Comments

Replacing my convertible roof motor.

Has anyone any experience or advice on replacing the roof motor on a 1964 Cadillac Deville .



  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service