Jason Edge 1964 Coupe de Ville Model Car -1

Views: 82

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Photos

  • Add Photos
  • View All

Forum

'64 Deville Conv. passenger power windows problem

Started by Michael Vogler in 1963/64 Cadillac Specific Discussion. Last reply by Michael Vogler 17 hours ago. 4 Replies

all four power windows work from the driver's control panel, but none of the passenger windows work from the passenger switches.  Is this a master switch problem or an wiring problem?   Thanks for…Continue

Time of year to be checking your antifreeze ( coolant ) numbers —-Nov

Started by Tony and Ginny 429 in 1963/64 Cadillac Specific Discussion 23 hours ago. 0 Replies

Good time of year to be checking your coolant to see what temp it will freeze at Giving  you enough time to do a coolant change— if it is time to do so —-or —if your freeze at temp numbers are to…Continue

Tags: check, Coolant

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge yesterday. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Interiors in the PNW

Started by keith price in Restoration Discussion. Last reply by Jason Edge yesterday. 3 Replies

Just wondering if anyone knows of a place to get interiors done in the Pacific Northwest. I'm looking at seats, door cards and headliner. I live in the Tacoma Washington area so west side is…Continue

Blog Posts

1964 Cadillac Fleetwood sixty special / transmission dipstick needed

Posted by Pablo on September 20, 2020 at 9:57pm 1 Comment

How are you doing folks, I’m looking for a transmission dipstick, any info I will appreciated, thank you very much

1963 Cadillac hood driver side hinge

Posted by Steven on September 16, 2020 at 9:23am 1 Comment

Hello,

 Does anyone know were I can buy a 1963 Cadillac hood driver side hinge or is there any other hinge that would fit? 

Thanks

Steven

Bad Guage?

Posted by Karl Schwarz on August 26, 2020 at 3:08pm 6 Comments

So I am troubleshooting my fuel gauge issue. I bought a new sender and tested it. It  it goes from 1-ohm (empty) to 35-ohm (full). When I test it (outside the tank), when the float is in the up (full) position it only moves the gauge to about 1/2 full. When at the bottom (empty) position the gauge shows empty. This is the same issue I have when I fill and then use the gas in the tank - the gauge never reads ore than half full. Based on what I've read on this thread it would seem like the…

Continue

Website

Posted by Fritz Seitz on August 11, 2020 at 2:35am 0 Comments

I have been working on a website-----www.fritzsautorepair.com-----

Does anyone have suggestions?

Videos

  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service