Does anybody have a detailed set of instructions on how the heater core comes out??? 

Is this from the inside on the car (disassemble the dash?) or from the engine compartment??

Views: 2043


You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Jeffrey D Pfile on June 20, 2014 at 9:36pm

thanks that just helped me out a bunch just tackled the getting it out part but some of the vacuum lines were broke and dried out any idea on a diagram for vacuum locations ? 

Comment by Frank Murch on December 16, 2013 at 5:25pm

It is not a fun job, but it is done.  I think the glove box liner needs to come out, the case is in 3 parts and the interior case needs to come out.  The "under the hood" part, I had to remove the hood hinge, the A/C air duct, and the case.  There are 3 studs under the bottom. The blower motor did not need to come out. 

Not a great job

Comment by Henry McGary on December 16, 2013 at 4:44pm

Thanks for info, planing to tackle mine this spring.

Comment by Frank Murch on December 15, 2013 at 8:53pm

 Here is the piece that needs to come out

Comment by Frank Murch on December 15, 2013 at 8:52pm

I had to remove the hood hinge and the vent path to the A/C to reach the bolts - I did not have to take the blower out. There are 3 studs on the bottom 

Comment by Frank Murch on December 15, 2013 at 8:49pm

Here are a few photos I would have liked to have seen before hand


  • Add Photos
  • View All


Bendix Power Brake Unit Power Section

Started by Mathis Richter in 1963/64 Cadillac Specific Discussion. Last reply by Chris Codd 6 hours ago. 7 Replies

Hi,I have a huge problem my POWER SECTION of the ``Master-VAC Power Brake unit 9´´Diameter ´´ from Bendix is Broken and I can't open it to replace al the rubber parts did some of you have auch Power…Continue

Third brake light -help please.

Started by paul k in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 13 hours ago. 8 Replies

Did anybody from the club install third brake light in the rear window in his Cadillac? I have problem to figure out how to do it. Can I just run wire from break pedal switch and second wire connect…Continue

Extra speakers in the cadillac.

Started by paul k in 1963/64 Cadillac Specific Discussion 13 hours ago. 0 Replies

Ok, I have another question. Since I will run wire for a brake light I might run speakers wires.I would like to install 2 extra speakers or maybe 4. What is best option. I do have 2 speakers already-…Continue

429 and 400 trans. for sale

Started by Mark C Bills in For Sale. Last reply by Tony and Ginny 429 yesterday. 6 Replies

I have an excellent running 429 with 400 trans.recently removed from my 64. It has electronic ignition, new water pump,new fan and clutch(not pictured),new fuel pump,Holley 650 vac. sec. carb. with…Continue

Blog Posts

1964 Cadillac Fleetwood sixty special / transmission dipstick needed

Posted by Pablo on September 20, 2020 at 9:57pm 1 Comment

How are you doing folks, I’m looking for a transmission dipstick, any info I will appreciated, thank you very much

1963 Cadillac hood driver side hinge

Posted by Steven on September 16, 2020 at 9:23am 1 Comment


 Does anyone know were I can buy a 1963 Cadillac hood driver side hinge or is there any other hinge that would fit? 



Bad Guage?

Posted by Karl Schwarz on August 26, 2020 at 3:08pm 6 Comments

So I am troubleshooting my fuel gauge issue. I bought a new sender and tested it. It  it goes from 1-ohm (empty) to 35-ohm (full). When I test it (outside the tank), when the float is in the up (full) position it only moves the gauge to about 1/2 full. When at the bottom (empty) position the gauge shows empty. This is the same issue I have when I fill and then use the gas in the tank - the gauge never reads ore than half full. Based on what I've read on this thread it would seem like the…



Posted by Fritz Seitz on August 11, 2020 at 2:35am 0 Comments

I have been working on a

Does anyone have suggestions?


  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service