Turn signal indicators
How do the fender turn signal indicators come off?
Comment
-
Comment by Jason Edge on May 21, 2013 at 4:37pm
-
If only change the indicator bulb you only need to remove the chrome top cover:
- Remove 4 headlight bezel screws and remove headlight
- take a screw screwdriver and flashlight and find the screw that angles diagonally up and remove.
- Lift top cover off.If you need to remove the complete assembly:
- disconnect the signal indicator dark blue wire at the connector that is held to the bottom of grill support bar on left and right via a push on clip
- Remove 4 headlight bezel screws and remove headlight bezels
- using a flashlight to guide you, remove the two 3/8" hex head screws holding indicator base to fender, using a 1/4" socket drive extension, Universal angle joint, and 3/8" socket.
- Lift assembly up and off and fish wire and connector up and out.tagged: "Turn Signal Indicator Removal"
Photos
Members
Forum
Headed to Birmingham Tomorrow!
Started by Jason Edge in General Discussion on Friday. 0 Replies 0 Likes
I have been quiet lately, and just wanted to jump in an chat a minute. I have back to back visits to potential CLC Winter Board and Grand National Sites, not to mention I have been pushing to get…Continue
On Busy Day Yesterday!
Started by Jason Edge in General Discussion on Friday. 0 Replies 0 Likes
Very busy day working the parts cars yesterday, pulling engine and transmission out parts car #59, getting parts car #60 off the car hauler, then parts car back up on car hauler for final…Continue
Replacement 63 Radiator Recommendations
Started by Mike Travers in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth on Tuesday. 1 Reply 0 Likes
My 61 year old radiator sprung a leak (actually a few leaks). What are you guys using as replacements? Are you replacing with copper or aluminum? How many rows are you running in the radiator? How's…Continue
T-3 low beam headlight
Started by Jeff Donaldson in Wanted to Buy Apr 29. 0 Replies 0 Likes
Hi,I need one T-3 low beam headlight if anyone has a spare they would like to sell.CheersJeffContinue
Blog Posts
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 0 Likes
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Vintage Air AC
Posted by Chase on March 21, 2024 at 5:55am 0 Comments 0 Likes
Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!
accumulator dryer
Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments 0 Likes
Who rebuilds original AC accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year , There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A What is everyone using ? I would prefer to be as original as possible. Thanks
'63 Eldorado trumpet horn + 2 standard horns restoration
Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment 0 Likes
My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns.
There is a restoration service called The Horn Works who my son…
ContinueEvents
© 2024 Created by Jason Edge.
Powered by
You need to be a member of 63/64 Cadillac Website to add comments!
Join 63/64 Cadillac Website