Larry Rees's Discussions (55)

Discussions Replied To (37) Replies Latest Activity

"Thanks Jason for the tips. The removal went well doing it that way. Larry"

Larry Rees replied May 25, 2024 to Wiper motor replacement

2 May 25, 2024
Reply by Larry Rees

"And whether the connectors are plugged in the right way at pump/ motor. Do you have…"

Larry Rees replied Apr 24, 2024 to windshield wiper/washer issue

9 Apr 24, 2024
Reply by Jason Edge

"Got switch working better but still same problem happening. Checking continuity on t…"

Larry Rees replied Apr 24, 2024 to windshield wiper/washer issue

9 Apr 24, 2024
Reply by Jason Edge

"Thanks Russ for the information. Where do i look for the ground connection at the sw…"

Larry Rees replied Apr 24, 2024 to windshield wiper/washer issue

9 Apr 24, 2024
Reply by Jason Edge

"Thanks Dennis for the information. Would you have a picture of the copper ground str…"

Larry Rees replied Apr 24, 2024 to windshield wiper/washer issue

9 Apr 24, 2024
Reply by Jason Edge

"I’m going to take it. We ended up talking outside the site"

Larry Rees replied Apr 23, 2024 to cornering lights

21 Apr 25, 2024
Reply by Jason Edge

"Loosened off the two bottom bolts at steering column base clamp and the two bottom f…"

Larry Rees replied Apr 20, 2024 to cornering lights

21 Apr 25, 2024
Reply by Jason Edge

"Ok I got the switch out and the green wire was broken at the plastic clamp. It was t…"

Larry Rees replied Mar 3, 2024 to cornering lights

21 Apr 25, 2024
Reply by Jason Edge

"I have a non Tilt column. All i can see is the turn switch at top of column"

Larry Rees replied Mar 2, 2024 to cornering lights

21 Apr 25, 2024
Reply by Jason Edge

"Also I forgot to mention that both cornering lights have now been tested with an ind…"

Larry Rees replied Mar 2, 2024 to cornering lights

21 Apr 25, 2024
Reply by Jason Edge

RSS

Photos

  • Add Photos
  • View All

Forum

CLC Membership dues are going up April 1. Join or Renew before March 31 & Save!

Started by Jason Edge in Chapter Discussion 14 hours ago. 0 Replies

Here is a breakdown of the rate increases Effective April 1:E-membership…Continue

1964 Comfort Control Power Servos & Transducers - Feedback on Rebuilding

Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge 15 hours ago. 2 Replies

I often receive requests for good 1964 AC Heat Comfort Control Power Servo’s and/or Transducers. I currently have 6 Power Servos and 3 transducers and all leak down with the vacuum pump.  Some look…Continue

64’ A/C Power Servo - Vacuum Actuator

Started by Jacob Foster in 1963/64 Cadillac Specific Discussion. Last reply by Linda M. Brooks on Monday. 2 Replies

Gents, good morning!I’m looking for advice on how to fix the A/C Power Servo on my 1964 Cadillac Deville. The unit itself seems to be working correctly, but the vacuum actuator is leaking off. Has…Continue

Transmission and power seats

Started by David Erickson in General Discussion. Last reply by Linda M. Brooks on Monday. 3 Replies

Couple of question on my 63  Park Avenue1.  I had my car worked on last summer by my mechanic who restores casr primarily.  He does not work on transmissions.  He said there was a small transmission…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service