Robert Alan Shannon
  • Male
  • Fletcher, OK
  • United States
 

Robert Alan Shannon's Page

This profile is set to private.

You must be a member of 63/64 Cadillac Website to view this page.

Join 63/64 Cadillac Website

 
 
 

Photos

  • Add Photos
  • View All

Forum

I'M BACK !!!!!!!!!!

Started by Tony and Ginny 429 in 1963/64 Cadillac Specific Discussion 1 minute ago. 0 Replies

ENJOY

Corner Light Issues

Started by Mark Borer in Restoration Discussion. Last reply by Mark Borer 2 minutes ago. 7 Replies

Hi Allam putting the 63 Convertible back togetheram currently putting the front goodies oni have operating turn signals but no cornering lightsi jumped power directly from the battery....they both…Continue

Tony has entered the building.

Started by Kevin Campbell in General Discussion 5 minutes ago. 0 Replies

Geez, you forget to pay ya power bill.Continue

Quick question!

Started by Haris dizdarevic in General Discussion. Last reply by Kevin Campbell 1 hour ago. 18 Replies

The metal coolant tube under the intake on the 390 engine can I use a rubber line and run it like that or do I need that metal line and if so what is it called? I can't find my original. It goes from…Continue

Blog Posts

Pinion seal

Posted by Michael Jarnagin on October 14, 2018 at 7:10pm 2 Comments

Can anyone give me a brief and easy way to replace the rear differential pinion seal mine is leaking and spraying gear lube everywhere. Thank you Michael 

Radio for sale:

Posted by Ray Schick on October 7, 2018 at 11:28am 0 Comments

Retro Sound Radio,

am-fm  with 30 pre sets,built in amp 18watts 40watts peak x 4 channels.

bass,treble,fader, balance

push button styling, Aux input for IPods.power antenna & amp turn on leads

works excellent $140.00 plus the shipping.…

Continue

Battery Cable Hold Down

Posted by Ray Schick on October 2, 2018 at 2:40pm 5 Comments

I was walking d own the hardware isle and “Boom” had a idea for these…

Continue

HVAC Vacuum Valve Clip-need the one for the Power Control side

Posted by Norman Silverman on September 17, 2018 at 8:15pm 58 Comments

Hi.

Update:

I removed both 7 nipple vacuum valves and called my buddy who owns a machine shop. Tomorrow we'll re-surface the valve faces and then I'll reinstall them. HOWEVER, the one that comes out easily and comes apart with no rivet is on the Power module side. It installs on one side with a small bolt, and on the other it is held on by a clip, WHICH IS MISSING ON MY CAR. I am going to assume it is the same clip that is used on the Control Module side. Anybody got one? Happy…

Continue

Videos

  • Add Videos
  • View All

© 2018   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service