Hi everyone,
When I originally purchased the car I had a full tank of bad fuel. I noticed there was a drain plug in the tank. I opened the plug and drained all the fuel. No issues.
Every since I reinstalled the plug I have an "ever so slight" drip. I'm thinking about pulling the plug again and reinstalling the plug with some thread sealant and some type of rubber gasket.
Anyone ever had a similar experience ? Any suggestions ?
Tags:
The gas tank drain bolt (plug) is the same plug used for the oil pan and differential and came with a copper gasket. Perhaps you left it off? If it is there make sure the surfaces are clean and no burs on the copper gasket. They compress a bit each time you install and you may just need another. If you don't use copper make sure it is gasoline resistant.
Thank you for the advice.
Gracias !
Started by Stephen Pechenik in 1963/64 Cadillac Specific Discussion. Last reply by Stephen Pechenik 6 minutes ago. 1 Reply 0 Likes
I am in the process of removing the belt trim on the doors of my Fleetwood. I need to find the rear door window stop location so that i can remove screws. Help.Also, I am replacing the vent window…Continue
Started by David Michael Bigeleisen in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 1 Reply 0 Likes
Dear Cadillac friends:I have a 1963 Fleetwood.The transmission dipstick has bubbles in it when I check the fluid.Also, the transmission shudders when I drive up a slight incline in reverse.I had the…Continue
Started by Jason Edge in Chapter Discussion. Last reply by Jason Edge on Tuesday. 1 Reply 0 Likes
Here is a breakdown of the rate increases Effective April 1:E-membership…Continue
Started by Jason Edge in Newsletters on Tuesday. 0 Replies 0 Likes
Here is another sneak peak of our next newsletter feature - Denis Binette's 14K mile 1964 Coupe de Ville. I hope to have this distributed within the next couple of weeks. …Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2026 Created by Jason Edge.
Powered by