Hi everyone,
When I originally purchased the car I had a full tank of bad fuel. I noticed there was a drain plug in the tank. I opened the plug and drained all the fuel. No issues.
Every since I reinstalled the plug I have an "ever so slight" drip. I'm thinking about pulling the plug again and reinstalling the plug with some thread sealant and some type of rubber gasket.
Anyone ever had a similar experience ? Any suggestions ?
Tags:
The gas tank drain bolt (plug) is the same plug used for the oil pan and differential and came with a copper gasket. Perhaps you left it off? If it is there make sure the surfaces are clean and no burs on the copper gasket. They compress a bit each time you install and you may just need another. If you don't use copper make sure it is gasoline resistant.
Thank you for the advice.
Gracias !
Started by Stephen Pechenik in Restoration Discussion. Last reply by Linda M. Brooks 8 hours ago. 3 Replies 0 Likes
I am readying my Fleetwood to be painted. I need to replace the driver's side left chrome eyebrow molding (below the headlights). It appears to be made from pot metal. Mine is broken and I need to…Continue
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion on Sunday. 0 Replies 0 Likes
Hi everyone I would like to know dose anybody here have a tissue holder fitted to their car if so could you please send me a picture of it thanks in advance Continue
Started by Jason Edge in 1963/64 Cadillac Specific Discussion on Saturday. 0 Replies 0 Likes
CLC Membership dues are going up April 1. Join or Renew between now and March 31 and save! You can even renew with current rates for up to 3 years!Here is a breakdown of the rate increases Effective…Continue
Started by Jason Edge in Chapter Discussion on Friday. 0 Replies 0 Likes
Here is a breakdown of the rate increases Effective April 1:E-membership…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
February 15, 2026 from 7pm to 8:30pm – Zoom
0 Comments 0 Likes
© 2026 Created by Jason Edge.
Powered by