Trip Meter
My trip spin knob or where it is connected is stripped. I can reset it but it takes work. Any suggestions on repair or replace? I can't find it in the shop manual. 64 DeVille Convertible.
Replies to This Discussion
-
Permalink Reply by Jason Edge on
-
It is a simple cable that mounts to the dash lip at bottom and threads into the back of the speedometer unit.
The rubber reset knob is often cracked or missing making it hard to turn the cable. You can get the rubber slip on reset knob from places like Caddy Daddy. If you think your cable is bad I have plenty for $20 ($15 for Chapter Members) + $10 s/h to US destinations.Jason.
-
Permalink Reply by John Inglesby on
-
Thanks Jason. I replaced the reset knob and its still spinning. So it must be the cable. I'll paypal you the $25.00. The wiper arms look great I thought I could get the wipers local but nobody carries them. I see OPG has them.
Members
Forum
Welcome Returning Member Maurice Hamelick from the Netherlands!
Started by Jason Edge in Chapter Discussion. Last reply by Maurice Hamelink 20 hours ago. 2 Replies 1 Like
I wanted to give a shout out to returning Chapter Member Maurice Hamelick with his 1963 Four Window Sedan de Ville which was featured in our July 2016 Newsletter. Check out the newsletter via the…Continue
Rear suspension project
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 4 Replies 0 Likes
I have started my rear suspension project with the intent to replace bushings on the control links and yoke, shocks, coils and spherical joint. I have the car on jack stands and the transaxle…Continue
4,442 Pounds of Cadillac Metal Cadmium Plated! - Pick-Up 12th batch Thursday
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Sunday. 3 Replies 0 Likes
Front door handle lights not working
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Kurt May 20. 3 Replies 0 Likes
My front door handle lights would not go on when I opened the doors. Bulbs were good and had power to them. Was not getting a ground. The door switch was corroded and wasn't making contact when the…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
