Trunk Light Socket Very Strange?
I went to replace the bulb in the trunk light socket and was met by something I had never seen before: the socket appears to be made in two thicknesses. First a wide one with appropriate cut outs on the side where the bulb nipples fit in, then a long slender shaft (with a cardboard tubular insert) down to the positive contact. I've never seen anything like this. Only thing I can figure is that it is designed to have a metal rod inside the cardboard shaft that allows the contact to touch the bulb that is locked in up top. However, the book says this is a #89 bulb (which is very small) and would not fit this setup.
Explanations?
Norm
Comment
-
Comment by Jason Edge on December 5, 2018 at 8:11am
-
Norm, I have bulbs, in fact some new ones, but out of the Mercury Switch. I will put you on my Wait List. Jason.
-
Comment by Norman Silverman on December 4, 2018 at 10:21pm
-
OK, the answer was on the help area of this site. Duh!
So, Jason, do you have a mercury switch for this?
Norm
Photos
Members
Forum
Troubleshooting drivability
Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe 1 hour ago. 3 Replies 0 Likes
Hey everyone. Last year I had some trouble keeping the Caddy running. A little backstory, car hadn’t ran in 30 years. Rebuilt the crankshaft. I had it running pretty well for a bit. Even drove it the…Continue
T3 Headlights
Started by Jeff Donaldson in General Discussion 3 hours ago. 0 Replies 0 Likes
Has anyone bought new oem headlights from Lectric Limited? They want $150 for a set of new remanufactured ones. Any advice would be appreciated.JeffContinue
Headed to Birmingham Tomorrow!
Started by Jason Edge in General Discussion on Friday. 0 Replies 0 Likes
I have been quiet lately, and just wanted to jump in an chat a minute. I have back to back visits to potential CLC Winter Board and Grand National Sites, not to mention I have been pushing to get…Continue
On Busy Day Yesterday!
Started by Jason Edge in General Discussion on Friday. 0 Replies 0 Likes
Very busy day working the parts cars yesterday, pulling engine and transmission out parts car #59, getting parts car #60 off the car hauler, then parts car back up on car hauler for final…Continue
Blog Posts
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 0 Likes
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Vintage Air AC
Posted by Chase on March 21, 2024 at 5:55am 0 Comments 1 Like
Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!
accumulator dryer
Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments 0 Likes
Who rebuilds original AC accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year , There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A What is everyone using ? I would prefer to be as original as possible. Thanks
'63 Eldorado trumpet horn + 2 standard horns restoration
Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment 0 Likes
My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns.
There is a restoration service called The Horn Works who my son…
ContinueEvents
© 2024 Created by Jason Edge.
Powered by
You need to be a member of 63/64 Cadillac Website to add comments!
Join 63/64 Cadillac Website