Well, the wife say we gotta have'em so I'm on the hunt for seat belts for the back seat of my SDV 4 window.

My question is, are the rears the same length as the front?. Near as I can tell, fronts are about 70+ inches or so.

I've been looking at after market, chrome latch belts that are pretty reasonable. Seat Belt Planet and Andoauto are a couple. Although not exact match to the fronts that are installed, they'll be fine for my driver. 

Haven't looked around at it yet to see if the mounting holes are there but hoping they are. Anything else I need to consider. I'm assuming if the holes are there, I just need the bolts and washers to mount them. 

Any insight appreciated.

Tom B

Views: 556

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Tom Bahner on February 22, 2015 at 6:31pm

Thanks all. 

Tom B.

Comment by Jason Edge on February 22, 2015 at 4:42pm

Yep, Mounting holes are there beneath the rear lower seat. Remove and you will see 4 rubber plugs. I use WD40 and the claw end of a hammer to remove as to not damage..and to pull right out. The rear seat belts have the same bucket and insert as the front, but instead of the retractors has short stout mounting brackets to attach to pre-drilled holes as seen below:

Comment by Robert Alan Shannon on February 22, 2015 at 2:58pm

The holes you need should be there according to Jason. Type in seat belts under "blogs". Good info on this. HTH.

Photos

  • Add Photos
  • View All

Forum

Dipstick seal

Started by Tosh Dickenson in 1963/64 Cadillac Specific Discussion 5 hours ago. 0 Replies

There appears to be some kind of felt washer around the top of my oil dipstick, presumable to seal off the dipstick tube. I've looked around the usual parts suppliers but came up empty. There's not…Continue

Transmission questions

Started by James Fraschieri in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Friday. 8 Replies

Hello all. New member and new to classic cadillacs so I have some questions. Last year I got my hands on a resto-mod 63 coupe deville project and have been making good progress till now. I don't have…Continue

Sneak Peak at our Next Newsletter Feature - Roy Brosi's 1963 Convertible & 1964 Airstream

Started by Jason Edge in Newsletters. Last reply by Dennis P. DiBari on Thursday. 1 Reply

I have been slowly plugging away at our next newsletter which will feature Roy Brosi's 1963 Convertible and his 1964 Airstream Camper and thought I would give you all a "Sneak Peek" at our next…Continue

WTS 1964 Sedan Deville w/all options 20k

Started by Tim in 1963/64 Cadillac Specific Discussion. Last reply by C. Van Tune on Thursday. 2 Replies

1964 Sedan Deville with the original 429 engine and TH400 transmission. Engine has approximately 91k miles on the odometer and runs very well. I've replaced the plugs with NOS AC44 plugs, replaced…Continue

Blog Posts

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

accumulator dryer

Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments

Who rebuilds original AC  accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year ,  There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A    What  is everyone using ? I would prefer to be as original as possible. Thanks

'63 Eldorado trumpet horn + 2 standard horns restoration

Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment

My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns. 

There is a restoration service called The Horn Works who my son…

Continue

Videos

  • Add Videos
  • View All

© 2024   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service