Gear for power vent window
Im having a hard time locating the gear for the power vent window in my 64 Eldo. The existing one has 14 teeth and all I seem to be finding are ones with 17 teeth. Any suggestions?
Thanks
Replies to This Discussion
-
Permalink Reply by SK on
-
The original gears seem to indeed have - or in my case had - only 14 teeth, while the reproduction has 17. I bought mine either from Hydro Electric or from TA Motor in Sweden. I believe it only opens 90 degrees.
Additionally, the other end of the gear is different. The gap where you bolt the window frame is much wider and does not surround the frame on all sides. Therefore, the vent window is not firmly attached to the gear, which is very annoying. How have you solved this problem? The original type clips are not sufficient.
The Auto City Classic gears seem to have the correct gap.
- ‹ Previous
- 1
- 2
- Next ›
Photos
Members
Forum
Trouble with the transmission in my 1963 Fleetwood
Started by David Michael Bigeleisen in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 12 hours ago. 1 Reply 0 Likes
Dear Cadillac friends:I have a 1963 Fleetwood.The transmission dipstick has bubbles in it when I check the fluid.Also, the transmission shudders when I drive up a slight incline in reverse.I had the…Continue
CLC Membership dues are going up April 1. Join or Renew before March 31 & Save!
Started by Jason Edge in Chapter Discussion. Last reply by Jason Edge on Tuesday. 1 Reply 0 Likes
Here is a breakdown of the rate increases Effective April 1:E-membership…Continue
Sneak Peek at our Next Newsletter Feature - Denis Binette's 14K Mile Coupe de Ville
Started by Jason Edge in Newsletters on Tuesday. 0 Replies 0 Likes
Here is another sneak peak of our next newsletter feature - Denis Binette's 14K mile 1964 Coupe de Ville. I hope to have this distributed within the next couple of weeks. …Continue
Rear Main Seal & Transmission Pump Seal
Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by CHRIS CARLSON Feb 27. 1 Reply 0 Likes
Hey everyone, I need to replace my transmission input seal before spring starts, I’ve been losing a lot of fluid post Sunday drive. I figured I’d do the rear main seal service bulletin at the same…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
New old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2026 Created by Jason Edge.
Powered by
