While the brake lights on my 1963 series 62 convertible do work, other drivers complain that they burn too dimly to be seen in daylight. Before I look for more complicated causes, can anyone tell me if there is a grounding point for them in the trunk?
Added by Joseph Rabbene on September 28, 2014 at 2:02pm — 2 Comments
I'm lucky enough to have received a complete set of the original Hamill seat belts (Model RFC-45-B) for my '63 as a birthday present from my wife. A soak in an ammonia solution along with some polish cleaned them up nicely, but as nice as they look, they don't function. Has anyone had any luck in freeing up the webbing that passes through the chrome receiver? Because the webbing is stuck the belts can't be adjusted.
Thanks,
Joe Rabbene
Added by Joseph Rabbene on April 6, 2014 at 9:30am — 4 Comments
I installed a tilt steering column from a 63 Caddy parts car in my 63 convertible and am having trouble with the horn. Does anyone recall if there are spacers, insulators, or washers around the plastic backed, brass horn ring? I can't tell from the service bulletin, but the horn shorts out and the contact ring is the location of the short. Any advice would be greatly appreciated.
Added by Joseph Rabbene on May 18, 2013 at 8:50am — 1 Comment
Started by Michael Monson in Wanted to Buy 6 hours ago. 0 Replies 0 Likes
Looking for a heater control valve 9.795 for my 1964 Deville. ThanksContinue
Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Kurt yesterday. 7 Replies 1 Like
Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light? Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue
Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Wednesday. 1 Reply 0 Likes
Hi everyone, I installed a new gas tank sender in my 63 after bench testing it and confirming ohm range on the bench.However after installing and filling it up, it only reads half full after filling…Continue
Started by Jeff Donaldson in General Discussion. Last reply by Dennis P. DiBari Feb 16. 1 Reply 0 Likes
Hi,It's time to do a brake job on my Fleetwood. When I imported my car from the US to Canada I had to have my car safety inspected before I could license it in the Privince of BC. After the…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2026 Created by Jason Edge.
Powered by