The rear windows will not go down on my 64 DeVille convertible. Front windows work fine. Any suggestions on how to get them down.
Thanks Richard
Tags:
Did you try from the individual window switches? From the master Driver Switch? With the lockout switch in the spring loaded far left Emergency Position?
Can you provide any details on how or when they stopped working? If they have worked did they work form individual switches and/or the master switch?
Thanks for the quick reply. This is a great forum. They were stuck up when I bought the car. I will try the Emergency position and let you know.
Thanks Richard
I am assuming then you tried from both the master switch and the individual window switches. Make sure ignition is on. With the Lock Out switch it doesn't matter. Ignition can be off. Basically bypasses the relay. It is easier to diagnose with a full picture of how things are working or not working before you just start diving into the rubber conduit between the driver door and the body of car... although breaks in the wires in this area is a common problem area. The fact your right front passenger window works (assuming from master switch and individual switch) makes you wonder if it could indeed be isolated issues at the rear qtr windows or isolated to feed wires in that rubber conduit. Again, it would be helpful to know the full details before jumping into anything. It is also easy enough to just pop the ash tray/lighter/switch receivers up in the back and make sure they have good contacts before tacking the driver door conduit.
I will go slow and try your recommendations.
Thanks for the help, Richard
Thanks for the quick reply. I will look into the wire harness in the door.
Thanks Richard
Did you get his figured out ?
My rear windows on the 64 won't run either.
Started by Jason Edge in General Discussion. Last reply by Kurt 3 hours ago. 6 Replies 0 Likes
I have got a flood of email, texts, about the 63 Eldo that recently bid up to $120,000 and thought I would share for those that have not seen it.Here is the link:…Continue
Started by Jason Edge in General Discussion 5 hours ago. 0 Replies 0 Likes
Incredibly, in 3 days I have had 3 people ask about replacing their fuel pump or even adding an electric fuel pump because there carb is not getting gas. It has gotten to the point I have copied and…Continue
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Monday. 13 Replies 0 Likes
Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Monday. 3 Replies 0 Likes
While enjoying the fruits of my labor on all new rear suspension and…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by