I have a 1963 Jetaway 315 4 speed Hydramatic that when it is parked for a few days the dipstick shows it is way overfull . Also when I first start it I must wait for almost a minute before it will go into any gear after a minute it works flawlessly. . I have been chasing leaks and the trans never leaks when driving or parked for 8 hours or less , After that the dipstick will show it is overfull and it leaks due to the fluid level being above the pan gasket level . I now have the pan gasket sealed and it still leaks from the dipstick tube. Did these cars leak when new when parked for several days?
Tags:
+1 on checking the transmission fluid when the car is running, at operating temp, and in neutral.
Common mistake for people to check it cold and engine off. Yes, it's pints, not quarts, on the dipstick.
As for being hesitant to go into gear after sitting for many days/weeks, my 21,000 mile survivor 1961 Series 62 coupe would take about 10-15 seconds after starting the engine and putting into gear before the car moved. (This wouldn't happen just one day after a drive, however.)
It was such a great driving car that I didn't want to mess with it. I did change the fluid/filter/gasket and never saw anything leaking beyond an occasion one-or two drips of clean pink trans fluid after a drive.
If your pan is truly over-full, you need to drain it. Too-full causes problems. Other than that, check all the connections, linkages, gaskets, etc. These cars did not have any "delayed propulsion" problem when new. But, now they're 62 years old.
Heck, I was born BEFORE 1961, and I'm slow getting into gear after "starting up" in the morning as well.
I have no leaks from the main font seal of the trans and I do check thee fluid level when warmed up and idling..
it shows way overfilled when checklng cold and not running after a day or so, Once it is running and warm the level is correct.
Started by Patrick Westphal in For Sale. Last reply by Jason Edge 14 hours ago. 1 Reply 0 Likes
Hey everyone,I have a set of front bumpers, both ends and the center section, that I am looking to sell. If you are looking for these contact me and we will talk about it. …Continue
Started by Norman Silverman in 1963/64 Cadillac Specific Discussion. Last reply by Norman Silverman yesterday. 5 Replies 0 Likes
Hello AllI am thinking about replacing the shocks on my 64 SDV. I want to do so with units that are closest to what was originally in the car in so far as ride quality. I believe these were gas…Continue
Started by Jason Edge in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 1 Reply 0 Likes
Last night I was installing the freshly cad plated inner fender to frame rear support brace rods and remembered how this has been often missing on the many parts cars I have brought in. The thing is…Continue
Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge yesterday. 2 Replies 0 Likes
I'm currently rounding up parts for a heater core replacement in my 1964 Deville. I'm looking for replacement hoses that connect to the heater core itself. It's a factory a/c car and has the metal…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by