my pump has gone out again in 63, 390. I dont know why, either too tight a belt or something else, been 2 or three since rebuild and 13k miles.. it was a gates unit. it seems for a while the cordone unit was the only one out there with the enclosed impeller but apparently, they are no longer available anywhere, even there company site doesn't list them. While searching, I found that rock auto now has a supplier with the enclosed impeller, https://www.usmotorworks.com/catalog/ through rock auto.. may give it a try,, anyway, its just for info as the enclosed impeller has been hard to come by, not sure it makes a difference, but I think its what was on the original motors..
Tags:
Hey Kim probably Chinese made junk
The enclosed impeller is what was on the original water pumps. What are you putting in your radiator? The coolant acts as a lubricant for the water pump.
I used on of the 50/50 antifreeze products out there,
Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 3 hours ago. 1 Reply 0 Likes
My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue
Started by Doug Scarrow in Wanted to Buy. Last reply by Dennis P. DiBari on Saturday. 3 Replies 0 Likes
for close to 20 years I have had a lovely Club Decal on my windshield now I wish to replace the windshield and would love to buy a decal if any one has one available See attached photosContinue
Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe on Tuesday. 2 Replies 0 Likes
Is anyone here planning on going to the Back to the 50’s car show in Minnesota?
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge Jun 15. 2 Replies 0 Likes
Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by