1963%20control%20code%20list.jpg

Jason, 

I was very interested in your article on "Dino". A well documented vehicle is a great project and achievement. Your comment on the outlet codes is the reason for this post.

I had been researching my 1963 62 Series Convertible and because the original owner protection plan listed the Cadillac Owner's Identification and the Selling Dealer as Cadillac Motor Car Division I was curious. When I requested an information from the GM Archives, I included this information. When I received the response it confirmed the fact that it was a factory executive's car. The Outlet code for my car is 943040, Cars in Co. Use for M.E. Fields, as shown on the attached list. I do not know if there are more codes than what I received but additional information may be available in the GM Archives. I hope this helps anyone else researching their car. Enjoy!

Views: 91

Reply to This

Replies to This Discussion

So here is a little information from inside GM.  There is and has been a program in GM where an employee of a certain level was assigned a current production vehicle to drive and evaluate.  I was part of this program while employed at GM.  It was called the PEP program which stood for Production Evaluation Program.  The amount of time that you drove the vehicle varies between 3 and 6 months and those vehicles were then sold as used cars either to dealers or on the open market.  It sounds like your vehicle was part of this program back in the day.  

Patrick,

I knew that it would take someone that worked for GM in the past to add some explanation of the auto's use. M.E. Fields was the assistant sales manager for the Central Region. I am currently in communications with someone who knew this gentleman. I will keep you updated. Thank you for the information. 

RSS

Photos

  • Add Photos
  • View All

Forum

Power Booster Install

Started by Rob Spring in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 3 hours ago. 4 Replies

Hey! I’ve seen the 63/64 power booster and master cylinder combination has been covered very clearly. I’m in the process of replacing mine. I was hoping someone could give me insight on a specific…Continue

Complete Front End Rebuild

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Mark Mata on Thursday. 1 Reply

I meant to make this a priority over the winter and didn't get that far. I've tried to source all the parts individually, but that is a daunting task. Partly because I don't want to miss any…Continue

1964 Cadillac Deville Neutral Safety switch and Oil Filter Housing Assembly

Started by Michael Monson in Wanted to Buy. Last reply by Russ Austin on Wednesday. 1 Reply

Hello, possibly looking a neutral safety switch for a 1964 Deville with the TH-400 and tilt steering.  Also, possibly looking for an oil filter housing assembly for a 1964 429 motor.  Starting to get…Continue

A Shout Out to Alan Grist & Some Pictures of His 1964 Series 62 4W Sedan

Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Wednesday. 2 Replies

As they say, Better Late Than Never!I want to give a shout out to 63/64 Chapter Member Alan Grist, who brought his 64 Series 62 Four Window Sedan, to the 2025 CLC Winter Board Meeting in Chattanooga,…Continue

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 13 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service