Tom & Kathleen Bahner’s 1963 SDV on 2024 CLC Kansas Driving Tour
On the 2024 Cadillac & LaSalle Cadillac & LaSalle Club National Driving Tour in Kansas, we have one 63/64 Cadillac Chapter member car on hand, Tom & Kathleen Bahner’s 1963 Four Window Sedan de Ville and of course as Director of the Chapter I have to share some pictures of this lovely couple and gorgeous car! These pictures were taken today in Marquette.
Replies to This Discussion
-
Permalink Reply by Tom Bahner on
-
Thank you Jason. It was great to finally meet you face to face. You definitely showed your dedication by traveling over 1200 miles to attend. Thanks for all you do for our Chapter and the CLC. This was our first driving tour and it was a blast. Very well organized with some sites we haven't been to in years and also sites we've never been to.
Tom and Kathleen
-
Permalink Reply by Dennis P. DiBari on
-
Hi Tom,
Just saw the pictures Jason just posted of the Driving Tour in Kansas. I have to say that your car is beautiful and the pictures turned out great. Great pictures and a great 63/64 Chapter!
Dennis DiBari
Cottekill, NY
-
Permalink Reply by Jason Edge on
-
Hi Tom, Left host hotel today and sitting on bed in Kansas City and will be slowly making my way back to NC in the next 3 days. It was a lot of fun hanging out with you and Kathleen and hope to see you two at one of our 2025 CLC events. It was actually 1300+ miles each or 2600 miles round trip, but worth every drip of gas to have this much fun. For any of you that have not attended a Grand National or National Driving Tour, you really do not know what you are missing.
Members
Forum
Welcome Returning Member Maurice Hamelick from the Netherlands!
Started by Jason Edge in Chapter Discussion. Last reply by Maurice Hamelink yesterday. 2 Replies 1 Like
I wanted to give a shout out to returning Chapter Member Maurice Hamelick with his 1963 Four Window Sedan de Ville which was featured in our July 2016 Newsletter. Check out the newsletter via the…Continue
Rear suspension project
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 4 Replies 0 Likes
I have started my rear suspension project with the intent to replace bushings on the control links and yoke, shocks, coils and spherical joint. I have the car on jack stands and the transaxle…Continue
4,442 Pounds of Cadillac Metal Cadmium Plated! - Pick-Up 12th batch Thursday
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Sunday. 3 Replies 0 Likes
Front door handle lights not working
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Kurt May 20. 3 Replies 0 Likes
My front door handle lights would not go on when I opened the doors. Bulbs were good and had power to them. Was not getting a ground. The door switch was corroded and wasn't making contact when the…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
