GM 1964 Cadillac info
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Photos

  • Add Photos
  • View All

Forum

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge 8 hours ago. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Grandpa’s Cadillac Restoration

Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 19 hours ago. 13 Replies

Hello friends! It’s been a while since I’ve visited this page. Last I left I had spoke about my late grandpa’s Cadillac that I planned on “restoring”, which really meant getting back on the road.…Continue

Crankshaft - ‘64 Sedan Deville

Started by Jordan Johansen-Moe in Wanted to Buy. Last reply by Jason Edge 23 hours ago. 1 Reply

Hello friends! I’m looking for a crankshaft for a 429 that will begin Grandpa’s Cadillac Restoration. I will be talking to a machine shop on Monday (fingers crossed). However, in the event I hear the…Continue

AC update

Started by Joe DiIaconi in Restoration Discussion. Last reply by Kevin Campbell on Friday. 11 Replies

Today's little project: I've been trying to squeeze as much AC out of this system as I possibly can living here in South Florida. Sunday when I was washing my engine I noticed some air escaping from…Continue

Blog Posts

1964 Cadillac Fleetwood sixty special / transmission dipstick needed

Posted by Pablo on September 20, 2020 at 9:57pm 1 Comment

How are you doing folks, I’m looking for a transmission dipstick, any info I will appreciated, thank you very much

1963 Cadillac hood driver side hinge

Posted by Steven on September 16, 2020 at 9:23am 1 Comment

Hello,

 Does anyone know were I can buy a 1963 Cadillac hood driver side hinge or is there any other hinge that would fit? 

Thanks

Steven

Bad Guage?

Posted by Karl Schwarz on August 26, 2020 at 3:08pm 5 Comments

So I am troubleshooting my fuel gauge issue. I bought a new sender and tested it. It  it goes from 1-ohm (empty) to 35-ohm (full). When I test it (outside the tank), when the float is in the up (full) position it only moves the gauge to about 1/2 full. When at the bottom (empty) position the gauge shows empty. This is the same issue I have when I fill and then use the gas in the tank - the gauge never reads ore than half full. Based on what I've read on this thread it would seem like the…

Continue

Website

Posted by Fritz Seitz on August 11, 2020 at 2:35am 0 Comments

I have been working on a website-----www.fritzsautorepair.com-----

Does anyone have suggestions?

Videos

  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service