All car Events (1)
September 26Thursday
-
11th Annual Cadillac Fall Festival
September 26, 2019 to September 29, 2019 – The Gilmore Car Museum, Hickory Corners, Michigan THE 11TH-ANNUAL CADILLAC FALL FESTIVAL WILL TAKE PLACE SEPTEMBER 26-29, 2019at the Museum & Research Center on the Gilmore Car Museum campus in Hickory Corners, Michigan. You can bet that all thi… Organized by CLCMRC | Type: clc, fall, festival, -, car, show
Photos
Members
Forum
Classic Cadillac Parts For Sale - Misc Items
Started by Jason Edge in For Sale. Last reply by Jason Edge 2 hours ago. 159 Replies 12 Likes
I have posted a few Misc items over on my Classic Cadillac Parts Facebook page at…Continue
A Drilling No-No .... That Worked!
Started by Jason Edge in General Discussion. Last reply by Jason Edge 8 hours ago. 17 Replies 0 Likes
Thought I would share a quick story regarding something I did that I generally do not recommend - Free handed drilling a broken front engine cover bolt. Before I jump into it I will say I do not…Continue
Current 1963/64 Cadillac Listings on eBay
Started by Jason Edge in For Sale. Last reply by Jason Edge 18 hours ago. 0 Replies 1 Like
To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue
Tags: ebay
Trunk Pull-down
Started by Brian and Dorothy Lewis in Restoration Discussion. Last reply by Jason Edge yesterday. 9 Replies 0 Likes
Hi gang. While reviewing the extensive photo archives on this site, I came across an excellent series of photos documenting a trunk pull-down assembly posted by Jason Edge. I really didn't even…Continue
Blog Posts
Starter Solenoid replacement-how difficult? Where to buy?
Posted by Norman Silverman on August 20, 2019 at 8:24pm 8 Comments 0 Likes
Hello All.
I believe the starter solenoid has gone bad in my 64 DeVille. When I turn the key, often all I get is a click, then if I try a few times again the starter turns perfectly. All battery cables are on tight and the battery is good. So, I believe this problem is the solenoid. Where do I buy the right solenoid and is it necessary to remove the starter in order to swap it out? …
ContinueFrame Markings
Posted by Gene McIlroy on August 12, 2019 at 6:26pm 1 Comment 0 Likes
Just got my frame back from powder coating so thought I would post photos of the front and rear frame markings.…
Lining up the drive shaft
Posted by Dominic Salemi on August 12, 2019 at 5:47pm 2 Comments 0 Likes
Can anyone shed some light on how to position the complete drive shaft in the correct position? I want to make sure my drive shaft is installed properly.
Thanks
Dominic
Upper A Arm Rubber Bumpers
Posted by Gene McIlroy on August 12, 2019 at 1:30pm 3 Comments 1 Like
I have found a very good replacement part for the Upper A Arm Bumpers. The top part is identical to the originals the bottom can be used as is or after a few minutes with a belt sander can be ground to the V shape as the originals were. The replacement bumpers are for a 2001 to 2005 S10 Sanoma or Blazer. Part number is on the box in the photos. First photo is the box next to the box is the S10 part and an original. Next photo shows my sanded down part next to an original.…
ContinueEvents
© 2019 Created by Jason Edge.
Powered by
