Mark Bartlett's Discussions (38)

Discussions Replied To (23) Replies Latest Activity

"I ran out of my 15 minutes Also see Jason's pics of motor mount placement probably s…"

Mark Bartlett replied Sep 14, 2023 to 64 Deville motor mounts replace

9 Sep 14, 2023

"Hello everyone again  I finally got both motor mounts in there was a couple of littl…"

Mark Bartlett replied Sep 14, 2023 to 64 Deville motor mounts replace

9 Sep 14, 2023

"Thanks for your input"

Mark Bartlett replied Sep 14, 2023 to 64 Deville motor mounts replace

9 Sep 14, 2023

"Thank you so much about the placement I probably would not have noticed that . I hav…"

Mark Bartlett replied Sep 14, 2023 to 64 Deville motor mounts replace

9 Sep 14, 2023

"Yaw mounts on the trans you mean those 2 little rubber mounts on the side     I have…"

Mark Bartlett replied Sep 13, 2023 to 64 Deville motor mounts replace

9 Sep 14, 2023

"Hi Patrick I sent  my clock to you today  let me know when you get it"

Mark Bartlett replied Aug 28, 2023 to 2 clocks that work

2 Aug 28, 2023
Reply by Mark Bartlett

"I am sure this is going to happen to me Thanks again"

Mark Bartlett replied Jul 26, 2023 to Back end of Cadillac doesnt seem Right when going over speed bumps

8 Jul 26, 2023
Reply by Mark Bartlett

"Hi A little update  Thanks Kurt for finding that ball joint in rear article I didnt…"

Mark Bartlett replied Jul 26, 2023 to Back end of Cadillac doesnt seem Right when going over speed bumps

8 Jul 26, 2023
Reply by Mark Bartlett

"Do you know who has them I called Advance auto and they talked to me like I didnt kn…"

Mark Bartlett replied Jul 18, 2023 to Back end of Cadillac doesnt seem Right when going over speed bumps

8 Jul 26, 2023
Reply by Mark Bartlett

"Ok Thanks "

Mark Bartlett replied Jun 26, 2023 to Timing chain cover R&R

14 Jun 26, 2023
Reply by Mark Bartlett

RSS

Photos

  • Add Photos
  • View All

Forum

Dino Radiator Leak - Time to Recore!

Started by Jason Edge in General Discussion. Last reply by Bill Wolf yesterday. 36 Replies

I had brought up the topic of radiator leaks as a discussion topic for our Chapter Zoom meet-up this past Sunday and thought I would share on our website for everyone and probably do a more formal…Continue

front seat crest

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Friday. 2 Replies

Original seats had a crest on the center arm rest.  Does anybody know where I could embose a crest in new material for a reupolstry?Continue

64 Replacing dash illumination lights-how much has to come out to get to all of them?

Started by Norman Silverman in General Discussion. Last reply by Norman Silverman on Thursday. 11 Replies

Hello AllI have taken off my dash top and started replacing dash bulbs with LED's for greater visibility. Some questions:1) To replace the Gauge bulb it looks like easier access is had by removing…Continue

Correct whitewalls

Started by Richard Stanley in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Wednesday. 3 Replies

 I just replaced my tires from Diamondback (I had bad results in the past from Coker).  It was the second time, due to the age of the tires.  About 18 years ago Diamondback made custom whitewalls…Continue

Tags: width, whitewall, correct

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service