Paint Fix
Hi Everybody,
In the attached JPEG is a scratch I picked up in October 2016 on one of the last rides of the season by a truck going the opposite way on a 2 lane road. You would have thought someone hurt my kids. Anyway, it is on the front drivers front fender above the trim piece. Any ideas on how to make it look respectable without painting the entire fender?
Replies to This Discussion
-
Permalink Reply by 3ft7bqmb7dryo on
-
sand to feather the edges. Color match the paint, and lay down some primer and paint with a air gun.
-
Permalink Reply by Tom Kissel on
-
Thanks Russ
-
-
Hi Tony the scratch is 1/2 inch long 1/8in wide
-
-
Hi Tom If you go to a good auto paint supplier they should have a camera that they put up against the exsiting paint and take a picture which they can match the color on your car. You could take them a fender skirt if easier and they can mix a small sample for you to touch up your scratch. I did this on a fender skirt and it matched amazingly well. Try it on a sample first. Good luck.
Members
Forum
Front door handle lights not working
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Kurt yesterday. 3 Replies 0 Likes
My front door handle lights would not go on when I opened the doors. Bulbs were good and had power to them. Was not getting a ground. The door switch was corroded and wasn't making contact when the…Continue
4,442 Pounds of Cadillac Metal Cadmium Plated! - Pick-Up 12th batch Thursday
Started by Jason Edge in General Discussion. Last reply by Chris Codd yesterday. 1 Reply 0 Likes
Vintage Promo Picture #4 - 1963 Fleetwood 60 Special in Nevada Silver
Started by Jason Edge in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies 0 Likes
Here is the 4th picture in my collection of "Promo Pictures" - another 1963 Fleetwood 60 Special. This 60 Special appears to be Nevada Silver, Paint Code 14. …Continue
lighted headlight switch
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Saturday. 2 Replies 1 Like
I had to replace the heater core in my 63 SDV, so I decided to replace all the dash lights with LED's. and replaced all the vacuum lines. While I was in there, I added a light to the headlight switch…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
