scratch.JPG

Hi Everybody,

In the attached JPEG is a scratch I picked up in October 2016 on one of the last rides of the season by a truck going the opposite way on a 2 lane road. You would have thought someone hurt my kids. Anyway, it is on the front drivers front fender above the trim piece. Any ideas on how to make it look respectable without painting the entire fender?     

Facebook Facebook

Views: 195

Reply to This

Replies to This Discussion

sand to feather the edges. Color match the paint, and lay down some primer and paint with a air gun.

Thanks Russ

Hi Tony the scratch is 1/2 inch long 1/8in wide

Hi Tom  If you go to a good auto paint supplier they should have a camera that they put up against the exsiting paint and take a picture which they can match the color on your car. You could take them a fender skirt if easier and they can mix a small sample for you to touch up your scratch. I did this on a fender skirt and it matched amazingly well. Try it on a sample first. Good luck.

RSS

Photos

  • Add Photos
  • View All

Forum

Bleeding brakes

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Tony Prichard 7 hours ago. 4 Replies

I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue

Power steering fluid

Started by Bobby Brown in General Discussion. Last reply by Tony Prichard 7 hours ago. 7 Replies

My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue

1963 AC evaporator core leaking?

Started by Mark Geertsma in 1963/64 Cadillac Specific Discussion. Last reply by Kenneth Barton yesterday. 2 Replies

Hi all,Again I have issues with my AC system. Had it refilled recently but within a few days the system was empty again. The AC mechanic added tracer fluid to check for leaks, but there are no…Continue

Tags: 1963, core, evaporator, AC

seat foam replacement

Started by Kevin Robles in 1963/64 Cadillac Specific Discussion. Last reply by Kevin Robles on Wednesday. 3 Replies

does anyone out there have any experience with seat foam replacement on  a 63/64 Cadillac.  I had my seats reupolstered  many years ago in original leather/fabric and they still look great, but the…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service