Started this discussion. Last reply by 3gk350qap28u3 Jan 11, 2017. 6 Replies 0 Likes
scratch.JPGHi Everybody,In the attached JPEG is a scratch I picked up in October 2016 on…Continue
Posted on December 7, 2013 at 1:56pm 5 Comments 0 Likes
Hi Guys,
I have a 64 Deville Convertible with the turbo hydra-matic without the controlled differential. I have fluid dripping out of 3 bolts on my Differential Carrier at a nice rate. I would like to correct this I have already re torqued them and the other bolts on the carrier. They still drip. In the manual section 11-10 note 9 they tell how to remove the carrier. What I don't understand is why do I have to remove the axle shafts to replace the gasket on the carrier.…
ContinuePosted on October 13, 2013 at 1:14pm 0 Comments 0 Likes
Hello Everyone, My 64 Convertible has the am/fm radio with a speaker in the front dash pad and in the rear seat. I would like to add the GM style reverb kit. I found a switch with attached wires at a garage sale in a coffee can of parts from a 64 Buick for $2.00 I see how it could attach to the speakers but I don't know if it then attaches to the radio or there is a special box I don't know about that the whole then goes to then to the radio. Anyone have any info about…
ContinuePosted on January 20, 2013 at 12:50pm 2 Comments 0 Likes
Hi Everyone, The picture isn't the best but I just installed to things in my 64 Deville. The item on the right which is hard to see is a tissue dispenser..but on the install drawing Cadillac calles it a tissue vallet. The big bread box on the left is a 12volt ARC 45 RPM Record Player. The record player is upside down so to play the side you want the record goes…
ContinuePosted on January 9, 2013 at 4:53pm 2 Comments 0 Likes
Hey Guys I have a question about my car antenna cabel. While removing the antenna connector from the AM/FM radio I pulled more on the cabel than connector and I ended up holding it in my hand with the con nector still in the radio. Now looking at it I'm woundering if its the reason I'm not pulling in the stations especially AM like I should. The cabel is black and part of that is stripped away exposing braded wire then some white tubing..should a solid wire be exposed after that? if…
ContinueStarted by Jeff Donaldson in General Discussion. Last reply by Jeff Donaldson 3 hours ago. 3 Replies 0 Likes
Hello Everyone,I tried to remove my clock today and couldn't seem to get it to rotate more than a 16th to an 8th of an inch. I followed the instuctions in the manual (counterclockwise approximately…Continue
Started by Jason Edge in For Sale 17 hours ago. 0 Replies 0 Likes
I will be out of town Dec 25-29 so anyone that needs something or wants a…Continue
Started by Jason Edge in General Discussion on Monday. 0 Replies 0 Likes
I have very limited space in my 3 bay garage with the left and right bay used for storage and work tables, etc leaving the narrow center aisle for my 1964 Coupe de Ville Dino. Six years ago I bought…Continue
Started by Stephen Pechenik in General Discussion. Last reply by Bill Wolf on Monday. 13 Replies 0 Likes
Hello Co-Members,I recently purchased a low mileage1963 Sedan Deville Park Avenue. It is extremely solid and runs well. Neverthelss, it has minor problems that need to be addressed before I can…Continue
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
ContinuePosted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Posted by Chase on March 21, 2024 at 5:55am 0 Comments 1 Like
Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!
Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments 0 Likes
Who rebuilds original AC accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year , There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A What is everyone using ? I would prefer to be as original as possible. Thanks
© 2024 Created by Jason Edge. Powered by
Comment Wall (1 comment)
You need to be a member of 63/64 Cadillac Website to add comments!
Join 63/64 Cadillac Website
Hi Tom,
It's good to see you here at the new 63/64 Cadillac Site.
Jason.