Hey Guys I have a question about my car antenna cabel. While removing the antenna connector from the AM/FM radio I pulled more on the cabel than connector and I ended up holding it in my hand with the con nector still in the radio.  Now looking at it I'm woundering if its the reason I'm not pulling in the stations especially AM like I should. The cabel is black and part of that is stripped away exposing braded wire then some white tubing..should a solid wire be exposed after that? if so how should I cut it correctly and how much should be exposed?

Thanks in Advance

Tom

        

Views: 188

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Jason Edge on January 10, 2013 at 12:13am

I've got VG nice solid original antenna cables for $20 + $6 s/h if your end has pulled apart. I can't remember trying to reapir one but if any doubt wiht yours I have plenty of nce VG+ used ones.

Jason .

Comment by Ray Schick on January 9, 2013 at 10:47pm
Uh Ohhhh……..

Photos

  • Add Photos
  • View All

Forum

Trouble with the transmission in my 1963 Fleetwood

Started by David Michael Bigeleisen in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 23 hours ago. 1 Reply

Dear Cadillac friends:I have a 1963 Fleetwood.The transmission dipstick has bubbles in it when I check the fluid.Also, the transmission shudders when I drive up a slight incline in reverse.I had the…Continue

CLC Membership dues are going up April 1. Join or Renew before March 31 & Save!

Started by Jason Edge in Chapter Discussion. Last reply by Jason Edge on Tuesday. 1 Reply

Here is a breakdown of the rate increases Effective April 1:E-membership…Continue

Sneak Peek at our Next Newsletter Feature - Denis Binette's 14K Mile Coupe de Ville

Started by Jason Edge in Newsletters on Tuesday. 0 Replies

Here is another sneak peak of our next newsletter feature - Denis Binette's 14K mile 1964 Coupe de Ville. I hope to have this distributed within the next couple of weeks. …Continue

Rear Main Seal & Transmission Pump Seal

Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by CHRIS CARLSON Feb 27. 1 Reply

Hey everyone, I need to replace my transmission input seal before spring starts, I’ve been losing a lot of fluid post Sunday drive. I figured I’d do the rear main seal service bulletin at the same…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service