-
Ted Mandalakis
- Male
- Somerset, NJ
- United States
- Blog Posts (5)
- Discussions (1)
- Events
- Photos
- Photo Albums
- Videos
Ted Mandalakis's Discussions
Looking for good working antenna assembly for 1964 deville Convertible
Started this discussion. Last reply by 39991p10fah2l Jul 22, 2014. 4 Replies 0 Likes
If anyone has a "ready to bolt in" antenna assembly available, I would be interested in talking. Drop me a line. Thanks, TedContinue
Tags: antenna
Ted Mandalakis's Page
Profile Information
- Do you own any 1963 & 1964 Cadillacs? If Yes, Year & Body Style
- 1964 6267 deville conv
- Cadillac LaSalle Club Membership Number? (Must be a member to Join Chapter & Website)
- 21386
- 1963/64 Cadillac Chapter Member?
- yes
Ted Mandalakis's Blog
Clock Operation - Chattering contacts points
Posted on February 26, 2013 at 11:45pm 1 Comment 0 Likes
Trying to work on the clock out of my 64. When I put a charge to it, the contact points chatter back and forth, sounding like a doorbell buzzer. I don't see the gears moving and the points never snap back. Has anyone experienced this? Ted
Clock Operation - Chattering contacts points
Posted on February 26, 2013 at 11:45pm 0 Comments 0 Likes
Trying to work on the clock out of my 64. When I put a charge to it, the contact points chatter back and forth, sounding like a doorbell buzzer. I don't see the gears moving and the points never snap back. Has anyone experienced this? Ted
Servicing the dashboard clock
Posted on January 3, 2013 at 12:59am 0 Comments 0 Likes
I found an old article I had printed years back on servicing our dash clocks. The article states to remove the three screws around the perimeter of the bezel and then the nut in the back. The back of my clock has a reddish washer (right in photo) that is pressed into the hole where the power cord prong extends. How do I get this out to clean the inside of the clock? Am I missing something? …
ContinueDetailing Under the Hood - Paint Colors
Posted on November 22, 2012 at 1:22pm 1 Comment 0 Likes
Happy Thanksgiving to all! I'm looking for the listing of paints for under the hood. Detailing the engine is my next challenge! I know this was on the old site but could not find it on the new site. Thanks.
Members
-
Travis J. Hensley Online
-
-
Forum
Steering slack/play
Started by Nile Bolen in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 4 minutes ago. 1 Reply 0 Likes
I checked the Help page and did a search on the site but didn't see any subjects on steering play/slack. Since I had someone complete a front end rebuild (Kanter kit, all the control arm bushings,…Continue
Power steering fluid
Started by Bobby Brown in General Discussion. Last reply by Dennis P. DiBari 7 hours ago. 9 Replies 0 Likes
My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue
Swapping 429 engine crankshafts
Started by Jacob Foster in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin 16 hours ago. 5 Replies 0 Likes
Hello All! I’m struggling to find an answer to this question, hoping a member can help. Can I swap the crankshaft from a 1966 429 w/TH400 to my 1964 429 w/TH400 trans? I came across an article that…Continue
1963/64 Cadillac Chapter July 2025 Newsletter Posted
Started by Jason Edge in Newsletters. Last reply by Dennis P. DiBari yesterday. 1 Reply 0 Likes
I have just completed and posted the July 2025, 1963/64 Cadillac Chapter Newsletter to our…Continue
Tags: Chapter, Newsletter, Posted, Cadillac, 1964
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
-
July 20, 2024 - 63/64 Cadillac Chapter Zoom Meet-Up
July 20, 2025 from 8pm to 9:30pm – Zoom
0 Comments 0 Likes
Videos
© 2025 Created by Jason Edge.
Powered by
Comment Wall (1 comment)
You need to be a member of 63/64 Cadillac Website to add comments!
Join 63/64 Cadillac Website
Hi Ted.Welcome to our new site!
Jason.