"Since the bench seat motor & transmission bracket fastener set had not been grouped and posted for sell, I took care of that today. See the 6 screws below: 2 at top to bolt bracket to seat bottom; 2 in center to mount seat transmission to…"
Thomas 's Discussions
Power seat motor and transmission mount
Started this discussion. Last reply by Jason Edge Oct 22. 3 Replies 0 Likes
Hello anyone have pics on how the power seat motor and transmission are mounted to the seat. My mount wasn't mounted it was laying on the floor thanks in advance
Thomas 's Page
Latest Activity
"I did some digging and found this picture of the bottom side of a 64 Cadillac with six way bench seat.
The large bracket attached to seat frame via two large Phillips Button Head Screws. You can see the head of one peaking through on the left. If…"
Power seat motor and transmission mount
Hello anyone have pics on how the power seat motor and transmission are mounted to the seat. My mount wasn't mounted it was laying on the floor thanks in advance
"Hi has anyone mounted the power seat and transmission to the actual seat if so how thanks in advance for any assistance"
"Hi Thomas, Welcome to the 63/64 Cadillac Chapter & Website. Be sure to tell us about your 1964 Fleetwood 60 Special when you get a chance. Jason."
Profile Information
- Do you own any 1963 & 1964 Cadillacs? If Yes, Year & Body Style
- 1964 Cadillac 60 Special Fleetwood Hardtop
- Cadillac LaSalle Club Membership Number? (Must be a member to Join Chapter & Website)
- 35795
- 1963/64 Cadillac Chapter Member?
- Not sure
Comment Wall (2 comments)
- At 11:50am on October 21, 2025,
Thomas said…
- Hi has anyone mounted the power seat and transmission to the actual seat if so how thanks in advance for any assistance
- At 3:56pm on June 19, 2025,
Jason Edge said…
Hi Thomas, Welcome to the 63/64 Cadillac Chapter & Website. Be sure to tell us about your 1964 Fleetwood 60 Special when you get a chance. Jason.
Photos
Members
Forum
1963/64 Cadillac Starting - Cranking System Basics
Started by Jason Edge in 1963/64 Cadillac Specific Discussion. Last reply by Linda M. Brooks 5 minutes ago. 5 Replies 1 Like
I have had this info written up for some time and meant to post so here it is. I will link to this from our Help Page:1963/64 Cadillac Starting - Cranking System Basics Wiring You have a positive…Continue
Why is the air stream of my 1964 CC system weak-even though the blower is blowing strongly?
Started by Norman Silverman in 1963/64 Cadillac Specific Discussion. Last reply by Norman Silverman 5 hours ago. 10 Replies 0 Likes
Hello AllI may have posted this before, but I was distracted by health issues and am now just getting back to trying to figure this out: The air stream (whether heat/def/AC) is weak, even thought I…Continue
Dino's Gas Lines Removed - Clean Up or Replace --> Member Advice
Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge yesterday. 8 Replies 0 Likes
As part of my undercarriage cleanup and and restoration of my 64 Coupe de Ville 'Dino', I removed both gas lines (my car has AC so it has a 5/16" supply line and 1/4" vent return line) to gain better…Continue
Jason's Escalade
Started by Marty Smith in General Discussion. Last reply by Jason Edge yesterday. 2 Replies 0 Likes
Cadillac Museum and Research Calendar I get to look at Jasons Escalade all month at work ! Great Photo…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
© 2025 Created by Jason Edge.
Powered by
