A while back my odometer quit working just as it was turning over 40000 mi. I took some time and pulled the speedo out expecting to see a stripped gear somewhere. What I found was a chunk broke out of the odometer dial. Its locked up tight.

I replaced the dial with a working one but would like to set the numbers to around 42000 instead of showing 004876.

My question, does anyone know the procedure for resetting the number on the odometer dial?? I don't want to break the gears inside on the working one.

Thanks for any help.

Tom B

Views: 194

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Jason Edge on November 26, 2014 at 5:35pm

It's been a while since I had one apart but like Tony said, I remember that you could just rotate the #'s to whatever you want to show once disassembled and dial removed. Also, If you need any internal hardware I probably have 3 dozen of these to pull from.

Photos

  • Add Photos
  • View All

Forum

Burning Rubber

Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Linda M. Brooks yesterday. 5 Replies

Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light?   Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue

Gas gauge only reads half when full

Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin yesterday. 1 Reply

Hi everyone, I installed a new gas tank sender in my 63 after bench testing it and confirming ohm range on the bench.However after installing and filling it up, it only reads half full after filling…Continue

64 Brakes

Started by Jeff Donaldson in General Discussion. Last reply by Dennis P. DiBari on Monday. 1 Reply

Hi,It's time to do a brake job on my Fleetwood. When I imported my car from the US to Canada I had to have my car safety inspected before I could license it in the Privince of BC. After the…Continue

Heater Core Replacement

Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson on Sunday. 6 Replies

I'm currently rounding up parts for a heater core replacement in my 1964 Deville.  I'm looking for replacement hoses that connect to the heater core itself.  It's a factory a/c car and has the metal…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service