Dino Diaries - Front Body to Frame Mount Boxes Cleaned & Coated.
Comment
-
Comment by Jason Edge on October 30, 2025 at 8:10pm
-
Just a quick update, I have since applied 2 coats of POR-15 Chassis Black to these front body to frame mount boxes ... but more importantly took the deep dive and have started cleaning the undercarriage to eventually treat everything with the POR-15 product. I started with the right rear floor pan as it is easiest to get to and will share more probably starting tomorrow. The POR-15 is great stuff, but is oil based, gives off strong fumes, and takes a few days to really cure... but worth the wait. More later!
-
-
Just to note, I ordered the POR-15 Gloss Black Top Coat direct from the company as Amazon only had it in pint size, and they sent me this 10% off link to share. Here is the link: https://por15.refr.cc/default/u/jasonedge64?s=sp&t=cp
-
-
Ps. The gold cad on your car looks great!! Definitely in a different league vs a car with everything just painted over!!
-
-
Yep, that is the chassis black. I ordered a quart of it and the gloss black. I’m doing 2 coats of rust prevention coating then 1 top coat. Will have to wait a couple days for top coat to get here. For items I can remove I will still go the Rustoleum engine primer & paint route. Always loved the finish.
-
Comment by Phillip Hill on October 26, 2025 at 7:30am
-
This what I have been using
-
-
I like the protective coating but is a duller, greyer black than I am use to so I ordered the POR 15 Chassis Black Top Coat. Did you also use the POR Top Coat, and if so are you using the chassis black ir gloss black or both? I’m thinking chassis black on floor pan and gloss black on frame to match what I started. I knew it was good stuff but was use to the glossier Rustoleum engine paint I had used on parts of the frame.
-
-
Just to ease your mind I have been using POR 15 on my car you won’t be disappointed as it is a premium product see attached before and after photos of the front endThis what I have been doing over the winter
Photos
Members
Forum
1963/64 Cadillac Starting - Cranking System Basics
Started by Jason Edge in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 5 hours ago. 11 Replies 1 Like
I have had this info written up for some time and meant to post so here it is. I will link to this from our Help Page:1963/64 Cadillac Starting - Cranking System Basics Wiring You have a positive…Continue
Why is the air stream of my 1964 CC system weak-even though the blower is blowing strongly?
Started by Norman Silverman in 1963/64 Cadillac Specific Discussion. Last reply by Norman Silverman yesterday. 10 Replies 0 Likes
Hello AllI may have posted this before, but I was distracted by health issues and am now just getting back to trying to figure this out: The air stream (whether heat/def/AC) is weak, even thought I…Continue
Dino's Gas Lines Removed - Clean Up or Replace --> Member Advice
Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge on Friday. 8 Replies 0 Likes
As part of my undercarriage cleanup and and restoration of my 64 Coupe de Ville 'Dino', I removed both gas lines (my car has AC so it has a 5/16" supply line and 1/4" vent return line) to gain better…Continue
Jason's Escalade
Started by Marty Smith in General Discussion. Last reply by Jason Edge on Friday. 2 Replies 0 Likes
Cadillac Museum and Research Calendar I get to look at Jasons Escalade all month at work ! Great Photo…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
-
November 23, 2025 - 63/64 Cadillac Chapter Zoom Meet-Up
November 23, 2025 from 7pm to 8:30pm – Zoom
0 Comments 0 Likes
© 2025 Created by Jason Edge.
Powered by
You need to be a member of 63/64 Cadillac Website to add comments!
Join 63/64 Cadillac Website