Hi all,
I am in the process of replacing my steering gear box. Upon removal I notice that the rag joint is showing some stress, my car has tilt wheel. My question is, are the rag joints common between tilt and non-tilt cars or are they different? So before I start researching for a replacement part I want to be sure I get the correct one. Thanks everyone.

Jim

Facebook Facebook

Views: 663

Reply to This

Replies to This Discussion

According  to the info in Tilt Steering Conversion under HELP Topics, they are different. I don't know the difference, mines non-tilt. HTH

Hi Jim, Tilt is smaller diameter on the column side. I have very nice, used non-tilt rag joints with excellent masticated rubber, ground wire etc. for $35 + s/h.  If you need tilt I would need to double check. Email at jasonedge@nc.rr.com if interested and provide a shipping address.

Hi Jason thanks for the quick response. I figured there had to be some difference. My car has tilt, if you get the chance to see if you have one I would appreciate it. Jim
I checked and I am out of the tilt rag joint. If Russ or one of the others don't have one, give me a shout at jasonedge@nc.rr.com and I will put you on the Wait List for one.

RSS

Photos

  • Add Photos
  • View All

Forum

The $120,000 1963 Eldorado on Bring a Trailer

Started by Jason Edge in General Discussion. Last reply by Jason Edge 4 hours ago. 7 Replies

I have got a flood of email, texts, about the 63 Eldo that recently bid up to $120,000 and thought I would share for those that have not seen it.Here is the link:…Continue

Fuel Supply System - Check Points Beyond the Fuel Pump

Started by Jason Edge in General Discussion yesterday. 0 Replies

Incredibly, in 3 days I have had 3 people ask about replacing their fuel pump or even adding an electric fuel pump because there carb is not getting gas.  It has gotten to the point I have copied and…Continue

Tags: System, Delivery, Fuel

Front grill

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Monday. 13 Replies

Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue

Houston we have a problem!

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Monday. 3 Replies

While enjoying the fruits of my labor on all new rear suspension and…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service