I have an issue with my left side lower bulb in the bumper end housing portion. The bulb that operates the backup light. I can't get a bulb to operate although I do get 12V when I put my tester to that center pin inside the bulb housing. I even added some solder to the tip of the bulb contact to see if the buidup would help contact, but no go. The bulb does take a bit of effort to insert as if it is contacting the spring loaded pin.
Dan
Tags:
U had this same issue and messed with the socket for a long time, but could not get it to work consistently - the spring at the base was just too old and had lost its springiness. I replaced the socket and all was well. I documented the process at the link below - it is really pretty easy and actually took much less time than I had spent fiddling with the original socket.
http://6364cadillac.ning.com/forum/topics/1963-tailight-backup-ligh...
Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by CHRIS CARLSON on Saturday. 1 Reply 0 Likes
Hey everyone, I need to replace my transmission input seal before spring starts, I’ve been losing a lot of fluid post Sunday drive. I figured I’d do the rear main seal service bulletin at the same…Continue
Started by Michael Monson in Wanted to Buy. Last reply by Michael Monson on Thursday. 2 Replies 0 Likes
Looking for a heater control valve 9.795 for my 1964 Deville. ThanksContinue
Started by Jeff Donaldson in General Discussion. Last reply by Logan Robb on Tuesday. 4 Replies 0 Likes
Hi,It's time to do a brake job on my Fleetwood. When I imported my car from the US to Canada I had to have my car safety inspected before I could license it in the Privince of BC. After the…Continue
Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Kurt Feb 22. 7 Replies 1 Like
Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light? Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2026 Created by Jason Edge.
Powered by