I have an issue with my left side lower bulb in the bumper end housing portion. The bulb that operates the backup light. I can't get a bulb to operate although I do get 12V when I put my tester to that center pin inside the bulb housing. I even added some solder to the tip of the bulb contact to see if the buidup would help contact, but no go. The bulb does take a bit of effort to insert as if it is contacting the spring loaded pin.
Dan
Tags:
U had this same issue and messed with the socket for a long time, but could not get it to work consistently - the spring at the base was just too old and had lost its springiness. I replaced the socket and all was well. I documented the process at the link below - it is really pretty easy and actually took much less time than I had spent fiddling with the original socket.
http://6364cadillac.ning.com/forum/topics/1963-tailight-backup-ligh...
Started by Sammy in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 6 hours ago. 3 Replies 0 Likes
Hello folks,on a drive this weekend I had to open the trunk. Used the remote in the glovebox and it popped open a bit, but further opening was very hard und slow. I stood on the side of a main street…Continue
Started by Ian Arnold in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge Aug 2. 3 Replies 0 Likes
Compression test 15 years ago was good. Not a lot of miles since then. Summer car.Last year had a oil pressure issue. Found an aluminum flake had stuck open oil pressure relief valve. (Low pressure…Continue
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Phillip Hill Jul 27. 2 Replies 0 Likes
I recently converted my dim yellow headlights to LED after nearly cleaning up a roo the other night see attached pics for before and after …Continue
Started by Russ Austin in General Discussion. Last reply by Russ Austin Jul 23. 2 Replies 0 Likes
What parts to your need for your Cadillac? Need a part to get it running or just to tidy things up a bit? Starters to nice A pillar moldings, my 1500 squarer footing shop is packed with parts. …Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2026 Created by Jason Edge.
Powered by