Need help installing rear brake line. Mine is totally out of the car. 64 Fleetwood. I'd like to know how the brake line is routed from master cylinder to flexible line in the back of car. Also where to attach it to the frame. THANKS
Tags:
There may be fasteners still on the frame. If I remember correctly, the lines ran along the center of the car along the X frame member. Ahead of the differential on the frame there is a fitting that allowed for the lines to run to the left and right wheels. I think it was the line for the rear passenger side that ran above the frame cross member over the rear axle. I can't remember (I don't have my shop manual handy) if the shop manual showed the brake line routing, but take a look.
Started by Jason Edge in General Discussion. Last reply by Jason Edge 1 hour ago. 7 Replies 0 Likes
I have got a flood of email, texts, about the 63 Eldo that recently bid up to $120,000 and thought I would share for those that have not seen it.Here is the link:…Continue
Started by Jason Edge in General Discussion yesterday. 0 Replies 0 Likes
Incredibly, in 3 days I have had 3 people ask about replacing their fuel pump or even adding an electric fuel pump because there carb is not getting gas. It has gotten to the point I have copied and…Continue
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Monday. 13 Replies 0 Likes
Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Monday. 3 Replies 0 Likes
While enjoying the fruits of my labor on all new rear suspension and…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by