Cadillac 40Amp Fuse
I purchased this fuse. It turns red hot and failed
Is this the correct fuse? The glass fuse works, no problems
I would like a metal fuse, but clearly this one is not good
Where can I get a good one???
- Attachments:
-
-
Cadillac 40Amp Fuse 1.JPG, 704 KB -
Cadillac 40Amp Fuse 2.JPG, 560 KB
-
Replies to This Discussion
-
Permalink Reply by a5c0048011b941599a2e58cc24e9eb2f on
-
What circuit is this for?
-
Permalink Reply by Frank Murch on
-
Windows and convertible top, in the fuse block left side under dash. You can see it if you lay down in the drivers foot well. It is the location of all the fuses
Thanks
-
-
Ok, I know that fuse, but have never had a reason to mess with it.
I'll leave it to more knowledgable people to answer.
Sounds like we shouldn't ever operate the power windows and the top at the same time. (Common sense, too.)
-
-
just listed https://www.ebay.com/itm/266503396737
Members
Forum
where to find 1963 Cadillac Plastic Door Pin Anchors
Started by Frank Murch in 1963/64 Cadillac Specific Discussion 13 hours ago. 0 Replies 0 Likes
Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue
Rear Main Seal Oil Leak Fix with Bearing Cap Modification
Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth 17 hours ago. 15 Replies 4 Likes
Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue
Future of CLC Judging
Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge on Thursday. 6 Replies 0 Likes
First, A Big Thank You to CLC Chief Judge Bill Anderson for taking on this daunting task of overhauling the CLC judging system. The old system was very good, however, I believe what Bill and the…Continue
front seat crest
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch on Tuesday. 3 Replies 0 Likes
Original seats had a crest on the center arm rest. Does anybody know where I could embose a crest in new material for a reupolstry?Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
Videos
© 2025 Created by Jason Edge.
Powered by
