I have a 63 cadillac park avenue.  My bulbs in the door panels in the front driver and passenger sides were out.  I replaced them today and no illumination.   My battery is fully charged and I tried starting the car.  Absolutely no power.  Started fine earlier in teh day.  No lights will come on, no turnover when I start the car--completely dead.  Any ideas as to what the problem might be.   

Views: 31

Reply to This

Replies to This Discussion

Hi Dave,

     Without being there to see it, I would first check both battery cables for proper connections; that the negative is grounded properly to the frame and then the positive cable -especially at the starter/solenoid (that nothing is shorted out).  Also, the ignition switch to see if juice is present when you turn the key.   I would start there and work my way through the wiring.  Without being there it's hard to detect.

Dennis DiBari 

Does the horn or headlight work? Check that the battery posts are clean and tight. Check the starter connections. The red wire comes off of the big post up to the fuse box and to the ignition switch. Check that there is power to the fuse box. Check the connector at the bottom at the red wire to power the fuse box. 

The purple wire on the ignition switch goes to the NSS. Check the large 2 wires on the NSS for continuity when the car is in park. The NSS should connect the 2 large wires together when in park. 

For the lights, check the body feed fuse. 

RSS

Photos

  • Add Photos
  • View All

Forum

Carburetor

Started by John Inglesby in 1963/64 Cadillac Specific Discussion 5 hours ago. 0 Replies

Any suggestions on carburetor rebuild for my 64 DeVille convertible. I guess it's a Carter or Rochester?Continue

Dino Diaries - Feb 25, 2025 - Open Up and Say Ahh!

Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari yesterday. 1 Reply

Just back with a new batch of cadmium plated parts, I like to imagine Dino saying "Ahh" as I sort through the next cad plated goodies to install. This morning I installed a cad plated fuel pump to…Continue

Pick Up of 11th Batch & Drop Off of 12th Batch For Cadmium Plating

Started by Jason Edge in General Discussion on Monday. 0 Replies

As I shared last night in our Chapter Zoom meeting, here is a picture of the 9 totes with fasteners and other parts that will be taken to Winston-Salem NC for cadmium plating. This will be my 12…Continue

Which Shocks for my 64 SDV are MOST like Originals?

Started by Norman Silverman in 1963/64 Cadillac Specific Discussion. Last reply by Norman Silverman on Monday. 4 Replies

I am considering replacing the shocks in my 64 SDV. They're not terrible, but are a little too wishy-washy. I want to replace them with shocks that most closely approximate the original damping rate…Continue

Blog Posts

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 5 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service