Does anyone have a wiring diagram for the cruise control cutoff switch? (Or can someone draw the diagram?). My installation of the cruise control system is going well, though I am taking it slowly so that I don’t damage the old parts, particularly the plastic connector to the speed cable in the speed dial. The power unit is in, the harness and cable is run, and the dash cover cut and dial installed. Btw, the speed cable appears to be working properly, though it is a little resistant. Is there a way to lubricate the cable?
Tags:
Gentlemen, I found the schematic on this website. Thank you, Jason! I also Googled cable lubrication and found a youtube video about it. These are amazing times! Thank you everyone!
Gentlemen, I found the schematic on this website. Thank you, Jason! I also Googled cable lubrication and found a youtube video about it. These are amazing times! Thank you everyone!
Before I accidentally short out my entire electrical system, there is an unused male plug (red or pink wire…) coming out the fuse block (with a set of other wires). I’m thinking it might be a “pigtail” for the cruise control. It appears that the cruise control female end will fit this. (The wires coming out of the brake light switch are pink and white and green? I’m having a little difficulty tracing the pink and white wire)? Any thoughts?
Also, if anyone has a cruise control, would you mind posting a picture of the cuttoff switch installed so I can see how it’s mounted? Thank you.
Also, if anyone has a cruise control, would you mind posting a picture of the cuttoff switch installed so I can see how it’s mounted? Thank you.
Thank you, Russ. These pictures are very helpful!
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Jacob Simmons on Thursday. 13 Replies 0 Likes
As is with my luck with this car (I still love it to pieces, just needs some TLC from neglect and not being driven) I’ve developed another issue. A small coolant leak has started from the Passenger…Continue
Started by Bill Wolf in General Discussion. Last reply by Dennis P. DiBari May 12. 6 Replies 0 Likes
I am trying to replace the front wheel cylinders on my 63 SDV and can't figure out how to get a wrench on the bolts holding them on. Does the backing plate have to come off and if so, how? Thank you…Continue
Started by Anthony Vanacore in For Sale. Last reply by Anthony Vanacore May 6. 5 Replies 0 Likes
Hello,My father and I are restoring our 63 series 62 conv, we had the chrome bezels for the window/seat switches rechromed. During this process we also installed factory power door locks to the…Continue
Started by Jason Edge in General Discussion May 3. 0 Replies 0 Likes
As I was documenting the non-AC 63 Eldorado parts car I bought in a couple months ago, the solid panel dash end panels intrigued me and thought I would share a couple of pictures and thoughts. First,…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2026 Created by Jason Edge.
Powered by