Any help on this 1964 Cadillac. My fuel gage is pegged over the full line. Is there a way I can tell without pulling everything apart to figure out if it is the gage or fuel unit. I disconnected the brown wire in the back trunk and it still stays over.
Thanks
Dominic
Tags:
An open connection will cause the fuel gauge to spike passed Full. try grounding the the brown wire. That should cause the fuel gauge to spike Empty. There are detailed testing procedures in the Help section.
http://6364cadillac.ning.com/profiles/blog/show?id=6543066%3ABlogPo...
Kurt
I found these instructions after I sent the question. I will go back there and try the grounding.
Thank you
Kurt
So if the gauge go to empty when I ground at the rear connection it probably is the unit in the tank?
That would be my guess. It is likely there is an open circuit somewhere in the sending unit.
Thank you
I will start there.
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 5 Replies 0 Likes
While enjoying the fruits of my labor on all new rear suspension and…Continue
Started by Rick Yasenchack in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies 0 Likes
I bought my 63 2-door convertible 62 series a few years back, previous owner said a new brake booster was just installed and that was why brake pedal was a rock. Did not know.Just had engine…Continue
Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Tuesday. 2 Replies 0 Likes
I'm looking for some info and hopefully some pictures on the commercial chassis dual battery setup. Is the second battery tray (driver side) , the same as the passenger side or is it mirrored? I'm…Continue
Started by Jason Edge in Chapter Discussion on Tuesday. 0 Replies 0 Likes
Chapter member Alan Clark and owner of a 1964 Eldorado sent this and wanted to share with everyone in case there are others nearby that might want to attend:"I'd like to invite the 63/64 chapter…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by