Any help on this 1964 Cadillac. My fuel gage is pegged over the full line. Is there a way I can tell without pulling everything apart to figure out if it is the gage or fuel unit. I disconnected the brown wire in the back trunk and it still stays over.
Thanks
Dominic
Tags:
An open connection will cause the fuel gauge to spike passed Full. try grounding the the brown wire. That should cause the fuel gauge to spike Empty. There are detailed testing procedures in the Help section.
http://6364cadillac.ning.com/profiles/blog/show?id=6543066%3ABlogPo...
Kurt
I found these instructions after I sent the question. I will go back there and try the grounding.
Thank you
Kurt
So if the gauge go to empty when I ground at the rear connection it probably is the unit in the tank?
That would be my guess. It is likely there is an open circuit somewhere in the sending unit.
Thank you
I will start there.
Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Alan Clark yesterday. 4 Replies 0 Likes
My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue
Started by Doug Scarrow in Wanted to Buy. Last reply by Dennis P. DiBari on Saturday. 3 Replies 0 Likes
for close to 20 years I have had a lovely Club Decal on my windshield now I wish to replace the windshield and would love to buy a decal if any one has one available See attached photosContinue
Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe Jun 17. 2 Replies 0 Likes
Is anyone here planning on going to the Back to the 50’s car show in Minnesota?
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge Jun 15. 2 Replies 0 Likes
Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by