Hydramatic pics?
Does anyone have any good pics of the Hydramatic linkage? I'm trying to adjust the linkage per the shop manual. I have found that my manual rod is maxed out on adjustment which will not allow me to adjust it correctly. I suspect the manual lever is bent but I don't want to experiment with bending it until I know for sure what it should look like. The figures in the shop manual don't really help me determine what the lever should look like. Here's a pic of mine. The transmission is in park in the pic.
Replies to This Discussion
-
Permalink Reply by 3ft7bqmb7dryo on
-
The lever is up side down in the bracket. Reposition the tab 180 deg and install it into the lever.
-
Permalink Reply by Kurt on
-
Yep. You are correct. I eventually figured that out. It's all good now. This started out as a NSS adjustment project. My reverse lights stayed on in Low too. After I adjusted the linkage I could then adjust the NSS. Reverse lights are good now but the NSS still leaks vacuum going from Dr to N. It's fine going from P->N->Dr, there is no vacuum leak but not so going the other direction. From Dr to N is leaks vacuum then going into P holds vacuum again.
Members
Forum
Add cruise control/Aftermarket Cruise control
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Michael Vogler 4 hours ago. 15 Replies 0 Likes
Late in the evenings, I wonder about things I will probably never do as I am not that crazy. However, I know someone out there has tried it or wanted it bad enough they have done it. My 64 Fltwd did…Continue
Steven Schneefuss' 1963 and Larry Rees' 1964 Spotlighted on Website
Started by Jason Edge in General Discussion yesterday. 0 Replies 0 Likes
If on a desktop or laptop, (or in desktop view mode on a mobile device) check out the header and you will see Steven Schneefuss' 1963 Coupe de Ville and Larry Rees' 1964 de Ville Convertible…Continue
Anyone Aware of a Raised Roof 75 Series?
Started by Jason Edge in General Discussion on Monday. 0 Replies 0 Likes
I received the email below and did not remember a raised roof 75 series but thought I would post here. Anyone know of or ever hear of this car?"I am a volunteer at Hillwood Museum and Gardens, the…Continue
Gump(Pat Westphal) you’re a gosh darn genius!
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Patrick Westphal Jul 25. 2 Replies 0 Likes
So I have been having problems with my brake lights. At first I thought it was both sides and turns out it is only the drivers side. Also, I thought the blinker worked and it didn’t and turned out…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
Videos
© 2025 Created by Jason Edge.
Powered by
